2023 Chevrolet Equinox Fuse Box Diagram & Amperage

Quick Answer

The 2023 Chevrolet Equinox features three main fuse box locations: under the hood in the engine compartment, inside the cabin on the passenger side kick panel, and in the rear cargo area.

Under-Hood Fuse Box

This fuse box is located in the engine compartment on the driver's side, near the battery. It houses fuses and relays for critical engine functions, powertrain control, ABS, and major electrical systems. Always disconnect the battery before servicing fuses or relays in this box.

Relay Locations (Under-Hood):

• RL1: Starter Relay
• RL2: Fuel Pump Relay
• RL3: PCM/ECM Relay
• RL4: HVAC Blower Motor Relay
• RL5: A/C Clutch Relay
• RL6: High Beam Headlight Relay
• RL7: Low Beam Headlight Relay

(Note: Relay locations may vary slightly depending on trim level. Always refer to your vehicle's owner's manual and the fuse box lid diagram for exact details.)

Instrument Panel Fuse Box (Passenger Side Kick Panel)

This fuse box is located inside the cabin, on the passenger side, behind the kick panel. Carefully pry off the kick panel to access the fuse box. This box typically controls interior electrical components, infotainment, power accessories, and some body control modules.

(Note: Fuse assignments can vary between trim levels and optional equipment. Always consult the diagram on the fuse box cover or your owner's manual for precise information.)

Rear Cargo Area Fuse Box

For the 2023 Chevrolet Equinox, an additional fuse box is typically located in the rear cargo area, often on the driver's side, behind a trim panel. This fuse box usually manages power for rear accessories, the liftgate, and other cargo area features.

(Reminder: Always cross-reference with the diagram printed on your fuse box lid and in your vehicle's owner's manual for the most accurate information specific to your Equinox.)

How to Test a Fuse

1. Locate the Fuse: Identify the suspected blown fuse using the diagrams above and your vehicle's fuse box legend.
2. Remove the Fuse: Use the plastic fuse puller usually found in one of the fuse boxes (or a pair of needle-nose pliers) to carefully remove the fuse.
3. Visual Inspection: Hold the fuse up to the light. If the metal wire or filament inside is broken or burnt, the fuse is blown and needs replacement.
4. Using a Multimeter (for a more definitive test):
   • Set your multimeter to continuity mode (looks like a speaker icon).
   • Touch one probe to each metal blade of the fuse.
   • A good fuse will show a reading close to zero ohms or emit a beep. A blown fuse will show an open circuit (OL or no reading) and no beep.
5. Replace with Correct Amperage: Always replace a blown fuse with a new one of the exact same amperage rating and type. Using a fuse with a higher amperage can cause severe electrical damage or fire.

Common Blown Fuses on This Vehicle

While any fuse can blow, some are more common due to high usage or specific scenarios. If you're experiencing an electrical issue, start by checking these fuses first:

• Cigar Lighter / 12V Outlets: Often blow due to incompatible or faulty chargers/accessories. Always check the F5 (20A Yellow) in the Instrument Panel Fuse Box and F1 (20A Yellow) in the Rear Cargo Area Fuse Box.
• Headlight Fuses: A blown headlight fuse (F5-F8 15A Blue in the Under-Hood box) usually results in one or both headlights not working. If a single bulb is out, it's more likely the bulb itself.
• Blower Motor Fuse: If your HVAC fan isn't working on any speed, check F11 (25A Natural) in the Under-Hood Fuse Box. This can often blow if the blower motor is failing or obstructed.
• Radio / Infotainment: If your radio or infotainment system suddenly goes blank, check F1 (10A Red) in the Instrument Panel Fuse Box.

Always ensure any accessory you plug in is operating correctly and isn't drawing too much power. If a fuse repeatedly blows after replacement, it indicates a deeper electrical short or component failure that requires professional diagnosis.

Find a trusted shop on Repairius.