2025 Jeep Wrangler Oil Capacity & Oil Filter Cross-Reference

The 2025 Jeep Wrangler takes between 5.0 and 7.0 quarts of oil, depending on the engine. For most models, you'll need 5.0 quarts of SAE 0W-20 full synthetic oil meeting the Stellantis MS-13340 specification.

Quick Answer: 2025 Wrangler 2.0L Turbo & 3.6L V6

• Oil Capacity (2.0L & 3.6L): 5.0 quarts / 4.7 liters
• Recommended Oil Weight: SAE 0W-20
• Required Oil Specification: API SP / ILSAC GF-6, Stellantis MS-6395 (or MS-13340)
• OEM Oil Filter (2.0L & 3.6L): Mopar 68517554AA (replaces 68191349AC)
• Aftermarket Filter Cross-Reference:
  • Fram: CH11665
  • Wix: WL10010
  • Mobil 1: M1C-456A

Capacity by Engine Option

Oil Change Interval

The 2025 Wrangler is equipped with an oil change indicator system. The vehicle will alert you when it's time for service. However, intervals should not exceed 1 year or 10,000 miles. Mopar recommends the following:

• Normal Duty: Follow the oil life monitoring system, up to 10,000 miles or 1 year.
• Severe Duty: Change oil every 3,500 to 4,000 miles. Severe duty includes frequent short trips, operation in dusty or off-road conditions, and towing.

Drain Plug Torque

• Drain Plug Torque (3.6L V6 & 2.0L Turbo): 20 ft-lbs (27 Nm)
• Crush Washer: Always use a new drain plug gasket if applicable, though many modern Jeep drain plugs feature a rubber O-ring. Inspect the O-ring for damage and replace the plug if it is torn or flattened.

How to Change the Oil (3.6L V6 / 2.0L Turbo)

1. Warm the engine to operating temperature.
2. Locate and remove the oil fill cap.
3. Safely raise the vehicle and locate the oil pan and drain plug.
4. Position a drain pan and remove the plug. Allow the oil to drain completely.
5. Locate the oil filter housing on top of the engine near the front. Use a 24mm socket to unscrew the cap.
6. Remove the old filter cartridge and the O-ring from the cap. Lubricate and install the new O-ring (included with the new filter), then click the new filter into the cap.
7. Screw the filter cap back into the housing and torque to 18 ft-lbs (25 Nm).
8. Reinstall the drain plug and torque to 20 ft-lbs.
9. Lower the vehicle and add 5.0 quarts of SAE 0W-20 synthetic oil.
10. Start the engine, let it run for 30 seconds, then shut it off. Wait 5 minutes and check the dipstick, topping off as needed.

Common Issues / Tips

• Filter Housing Cracks: The plastic oil filter housing cap and assembly can become brittle and crack if over-torqued. Always use a torque wrench and set it to the correct specification (18 ft-lbs for the cap).
• Correct Filter Type: The 2.0L Turbo and 3.6L V6 use a cartridge-style filter, not a traditional spin-on can. Ensure you have the correct type before starting the job.
• Oil Specification: Using an oil that meets the Stellantis MS-13340 or MS-6395 spec is critical for warranty compliance and long-term engine health.

Need an oil change? Find a trusted shop on Repairius.