2022 Toyota RAV4 Oil Capacity & Filter Guide

Quick Answer

• Oil Capacity: 4.8 quarts / 4.5 liters (with filter)
• Recommended Oil Weight: 0W-16
• Oil Specification: API SN/SP or ILSAC GF-6B
• Oil Filter Part Number:
  • OEM: 90915-YZZN1
  • Fram: XG9972
  • Wix: WL10290

Capacity by Engine Option

For the 2022 model year, the non-hybrid Toyota RAV4 is equipped with a single engine option, the 2.5L 4-cylinder A25A-FKS.

Note: The RAV4 Hybrid uses a different engine with different specifications.

Oil Change Interval

Toyota recommends an oil change interval based on driving conditions:

• Normal Service: Every 10,000 miles or 12 months, whichever comes first.
• Severe Duty: Every 5,000 miles or 6 months. Severe duty includes frequent short trips (especially in cold weather), extensive idling or low-speed driving (like delivery or police use), and driving on dirt/dusty roads.

Drain Plug Torque

When reinstalling the oil drain plug, it is critical to tighten it to the correct specification to prevent leaks or damage to the oil pan.

• Drain Plug Torque: 30 ft-lbs (40 Nm)
• Crush Washer: Always use a new OEM crush washer (Part # 90430-12031) to ensure a proper seal.

How to Change the Oil

A DIY oil change on the 2022 RAV4 is straightforward. Here are the basic steps:

1. Warm Up: Run the engine for a few minutes to warm the oil, which helps it drain completely.
2. Lift & Secure: Safely lift the front of the vehicle using ramps or a jack and jack stands.
3. Drain Oil: Place a drain pan under the oil pan, remove the 14mm drain plug, and let the oil drain fully.
4. Replace Filter: The RAV4 uses a cartridge-style filter. Remove the filter housing cap using a 64mm oil filter wrench (special tool). Replace the old filter cartridge and the two O-rings (one large, one small) on the housing cap. Lubricate the new O-rings with fresh oil before installation.
5. Reinstall: Screw the filter housing back on and torque to 18 ft-lbs. Reinstall the oil drain plug with a new crush washer and torque to 30 ft-lbs.
6. Refill: Lower the vehicle. Refill the engine with 4.8 quarts of fresh 0W-16 synthetic oil.
7. Check Level: Start the engine for 30 seconds, shut it off, wait a few minutes for the oil to settle, and then check the dipstick to confirm the level is correct. Top off if necessary.

Common Issues / Tips

• Correct Oil Weight: The A25A-FKS engine is specifically designed for ultra-low viscosity 0W-16 oil to achieve its targeted fuel efficiency and performance. While 0W-20 can be used as a temporary substitute if 0W-16 is unavailable, you should switch back to the recommended grade at the next oil change. Do not use heavier weights like 5W-30.
• Cartridge Filter O-Rings: It is absolutely essential to replace both rubber O-rings on the filter housing cap during every filter change. Reusing old, flattened O-rings is a common cause of significant oil leaks.
• Skid Plate Removal: Accessing the drain plug and filter requires removing a small plastic access panel or, on some trim levels, a larger portion of the engine splash shield held on by 10mm bolts and plastic clips.

Need an oil change? Find a trusted shop on Repairius.