2024 Toyota Tundra Oil Capacity & Filter

The 2024 Toyota Tundra with its i-FORCE MAX 3.4L Twin-Turbo V6 engine takes 7.7 quarts (7.3 liters) of 0W-20 engine oil meeting API SP or ILSAC GF-6 specifications.

Quick answer

• Oil Capacity: 7.7 quarts (7.3 liters)
• Recommended Oil Weight: 0W-20
• Oil Specification: API SP or ILSAC GF-6
• OEM Oil Filter Part Number: 04152-YZZD4
• Aftermarket Oil Filter Cross-References:
  • Fram: CH12678
  • Wix: WL10010
  • Mobil 1: M1C-153A

Capacity by engine option

Oil change interval

Toyota recommends changing your oil every 10,000 miles or 12 months for normal driving conditions. For severe duty, such as towing, heavy loads, or dusty conditions, it's advisable to shorten the interval to 5,000 miles or 6 months.

Drain plug torque

The oil drain plug on the 2024 Toyota Tundra should be torqued to 30 ft-lbs (41 Nm). Always use a new crush washer with each oil change to ensure a proper seal. The OEM crush washer part number is 90430-12031.

How to change the oil

1. Warm up the engine to operating temperature for a few minutes.
2. Locate and remove the oil drain plug from the oil pan while placing an oil pan beneath to catch the old oil.
3. Allow all the old oil to drain completely.
4. Replace the crush washer and reinstall the drain plug, tightening it to the specified torque.
5. Locate and remove the oil filter housing (cartridge style).
6. Replace the old oil filter cartridge with a new one, ensuring the O-rings are properly seated and lubricated.
7. Install the oil filter housing, tightening it to the specified torque (consult your owner's manual or a service manual for the exact torque).
8. Refill the engine with 7.7 quarts of new 0W-20 engine oil.
9. Start the engine and check for leaks. Allow the engine to run for a few minutes, then shut it off.
10. After a few minutes, check the oil level with the dipstick and adjust if necessary.

Common issues / tips

• Cartridge-style oil filter: The 2024 Tundra uses a cartridge-style oil filter, which requires a specific cap wrench for removal. Ensure you have the correct tool before starting the oil change.
• Engine cover removal: You may need to remove a plastic engine cover to access the oil filter and fill cap. These are typically held on by clips or easily removable bolts.
• Oil type is crucial: The twin-turbo engine is highly sensitive to the correct oil viscosity (0W-20) and specifications (API SP or ILSAC GF-6). Using an incorrect oil can lead to premature engine wear and potential warranty issues.
• Crush washer: Always replace the crush washer on the drain plug. This is a small but critical component that prevents oil leaks.

Need an oil change? Find a trusted shop on Repairius.