2021 Ford Escape Bulb Size Guide

Quick Reference Bulb Size Chart: 2021 Ford Escape

Note: Higher trim levels of the 2021 Ford Escape (like the Titanium) feature full LED headlight assemblies. In these models, the low beam, high beam, and DRL are all integrated LED units and cannot be replaced as individual bulbs. The entire headlight assembly must be replaced if a light fails.

LED vs. Halogen Upgrade Considerations

Upgrading your 2021 Ford Escape's halogen bulbs to LED can provide a brighter, more modern look. However, there are a few things to keep in mind:

• CANBUS Errors: The 2021 Ford Escape uses a CANBUS system to monitor the vehicle's lighting. Since LEDs draw less power than halogen bulbs, the system may think a bulb is burnt out, leading to a "bulb out" warning on your dashboard. To fix this, you may need to install a CANBUS resistor or an anti-flicker decoder.
• Adapters: Some LED bulbs may not fit directly into the stock housing. You might need an adapter to secure the bulb properly. This is especially common for headlight bulbs.
• Polarity: Unlike halogen bulbs, LED bulbs are polarity-sensitive. If an LED bulb doesn't light up when you first install it, try flipping it 180 degrees.

How to Replace Each Bulb

Here are some quick tips for replacing the bulbs in your 2021 Ford Escape:

• Headlights: The low and high beam bulbs are accessible through the back of the headlight housing. You may need to remove a dust cover to get to them. Turn the bulb counter-clockwise to remove it.
• Fog Lights: These are typically accessed from underneath the front bumper or by removing a plastic splash shield in the wheel well.
• Turn Signals, Brake, and Tail Lights: These bulbs are located in the rear tail light assembly. You'll need to open the trunk and remove a cover panel to access the back of the assembly. A few nuts hold the assembly in place. Once removed, the bulb sockets can be twisted and pulled out.
• License Plate Lights: These small bulbs are housed in a plastic lens above the license plate. A small screwdriver can be used to gently pry the lens out.
• Interior Dome/Map Lights: A plastic trim removal tool is recommended to gently pry off the clear plastic covers for the dome and map lights.

Common Lighting Issues for this Generation

The 2018-present generation of the Ford Escape is generally reliable, but a few common lighting issues have been reported:

• Premature Burnout: Some owners have reported that the stock halogen headlight bulbs burn out prematurely. Upgrading to a higher-quality halogen bulb or an LED conversion kit can remedy this.
• Moisture in Headlight Assembly: Condensation or moisture inside the headlight housing can cause bulbs to fail and may indicate a bad seal. If this happens, the entire headlight assembly may need to be replaced.

Find a trusted shop on Repairius.