2019 Ford Escape Bulb Size Guide

Quick Reference Bulb Size Chart: 2019 Ford Escape

Note: The 2019 Ford Escape primarily uses halogen and incandescent bulbs across its trims (S, SE, SEL, and Titanium). Higher trims like the Titanium may feature factory HID or LED options, particularly for the main headlights. Always double-check your specific vehicle's configuration before purchasing replacement bulbs.

LED vs. Halogen Upgrade Considerations

Upgrading your 2019 Ford Escape's factory halogen bulbs to LEDs can provide a significant improvement in brightness, longevity, and energy efficiency. However, there are a few important factors to consider before making the switch.

• CANBUS Errors: The Escape's computer system (CANBUS) monitors the electrical current drawn by the lighting system. Since LEDs draw much less power than halogen bulbs, the system might mistakenly believe a bulb is burnt out. This can trigger a "bulb out" warning light on your dashboard. To prevent this, you will likely need to install "CANBUS-ready" LED bulbs or add an external resistor to mimic the load of a halogen bulb.
• Adapter Harnesses: While many LED replacement bulbs are designed to be plug-and-play, some locations, particularly the headlights, might require a specific adapter harness to connect securely to the factory wiring. Check with the LED bulb manufacturer to see if an adapter is needed for your specific application.
• Beam Pattern: When upgrading headlights, it's crucial to choose high-quality LED bulbs that are designed to replicate the beam pattern of the original halogen bulbs. Poorly designed LEDs can scatter light, causing glare for oncoming drivers and reducing your own visibility.

How to Replace Each Bulb

Replacing bulbs on the 2019 Escape is generally straightforward. Here are some quick tips for each location:

• Headlights (Low and High Beam): Access the back of the headlight housing through the engine bay. You may need to remove a dust cover. The bulbs twist out of their sockets.
• Fog Lights: These are typically accessed from underneath the front bumper or by removing a small plastic panel in the wheel well.
• Front Turn Signals: Located in the main headlight housing, they are accessed similarly to the headlight bulbs.
• Rear Turn Signal, Brake, and Tail Lights: Open the rear hatch to access the screws or bolts holding the tail light assembly in place. Carefully remove the assembly to access the bulbs on the back.
• Reverse Lights: These are also located in the tail light assembly.
• License Plate Lights: Look for small plastic housings above the license plate. These usually have a small tab you can press to release the lens and access the bulb.
• Side Markers: The front side marker is located in the headlight assembly. The rear side marker is part of the tail light assembly.
• Dome and Map Lights: Use a plastic trim removal tool to gently pry off the clear plastic lens to access the bulbs.

Common Lighting Issues for This Generation

The 2017-2019 Ford Escape generation is generally reliable, but a few common lighting issues can occur:

• Premature Burnout: Some owners report that halogen bulbs, especially headlights, can burn out prematurely. This can sometimes be caused by voltage irregularities or even touching the glass of the new bulb with bare hands during installation (oils can cause hot spots).
• Condensation in Headlight Housings: Over time, the seals on the headlight assemblies can degrade, allowing moisture to enter. This can cause bulbs to fail and will eventually require the entire housing to be replaced or resealed.
• Wiring Harness Issues: In rare cases, the sockets or wiring harnesses can become brittle or corroded, leading to intermittent light function. If a new bulb doesn't fix the problem, inspect the socket and connector for any signs of damage.

Whether you're performing a simple bulb swap or upgrading your entire lighting system, having the right information is key. For more complex electrical diagnostics or repairs, it's always best to consult a professional.

Find a trusted shop on Repairius.