2023 Ford F-150 Oil Capacity & Filter Guide

The 2023 Ford F-150 requires between 6.0 and 7.75 quarts (5.7L and 7.3L) of oil, depending on the engine. For the popular 3.5L EcoBoost V6, you'll need 6.0 quarts of 5W-30 synthetic blend oil that meets Ford's WSS-M2C961-A1 specification.

Quick Answer

• Oil Capacity: 6.0 to 7.75 quarts (see table below)
• Recommended Oil Weight: 5W-30 (3.5L EcoBoost, 5.0L V8) or 5W-20 (3.3L V6)
• Oil Specification: Ford WSS-M2C961-A1 (5W-30) or WSS-M2C960-A1 (5W-20)
• Oil Filter (3.5L EcoBoost & 5.0L V8):
  • OEM: FL-500S
  • Fram: PH10575
  • Wix: WL10040
  • Mobil 1: M1-212A
• Oil Filter (3.3L V6):
  • OEM: FL-910S
  • Fram: PH3614
  • Wix: 51348
  • Mobil 1: M1-102A

Capacity by Engine Option

The 2023 F-150 was available with several engine choices, each with a specific oil requirement.

Oil Change Interval

Ford utilizes an Intelligent Oil-Life Monitor (IOLM) that determines the oil change interval based on your driving habits. The system will display a message in the instrument cluster when it's time for a change. However, Ford provides the following guidelines:

• Normal Duty: Change oil every 7,500–10,000 miles or as indicated by the IOLM.
• Severe Duty: Change oil every 3,000–5,000 miles. Severe duty includes frequent towing, extensive idling, operating in extreme hot or cold temperatures, or using E85 fuel more than 50% of the time.

Drain Plug Torque

Properly tightening the oil drain plug is critical to prevent leaks.

• Drain Plug Torque: 19 lb-ft (26 Nm).
• Crush Washer: The drain plug uses a rubber gasket and is designed to be reused. However, it is best practice to inspect it for damage and replace it if it appears hardened, cracked, or deformed. Consult your dealer for the correct replacement part if needed.

How to Change the Oil

1. Run the engine for a few minutes to warm the oil.
2. Safely raise and support the vehicle.
3. Place a drain pan under the oil pan and remove the drain plug.
4. Allow the oil to drain completely, then remove the oil filter.
5. Apply a light coat of new oil to the gasket of the new filter and install it, hand-tightening it another 3/4 turn once the gasket makes contact.
6. Reinstall the drain plug and torque it to 19 lb-ft.
7. Fill the engine with the correct amount and viscosity of oil.
8. Start the engine, check for leaks, and then shut it off. After a few minutes, re-check the oil level and top off if necessary.
9. Reset the Intelligent Oil-Life Monitor through the vehicle's information display.

Common Issues / Tips

• Plastic Drain Plug: Many F-150s now come with a yellow plastic drain plug. It requires only a quarter-turn to release and does not require significant force. Do not use a wrench on it. Replace the O-ring seal with each oil change.
• Access: On 4x4 models, the front differential can make accessing the oil filter a bit tight. A cap-style filter wrench can be helpful.
• IOLM Reset: Forgetting to reset the oil life monitor is a common oversight. This is a critical step to ensure you get timely reminders for your next service.

Need an oil change? Find a trusted shop on Repairius.