2024 Honda Civic Oil Capacity & Filter Guide

The 2024 Honda Civic takes between 3.7 and 5.7 quarts of oil depending on your engine model, with most common trims requiring either 3.7 quarts (1.5L Turbo) or 4.4 quarts (2.0L Naturally Aspirated) of 0W-20 full synthetic oil. As an ASE-certified master technician, I always emphasize that using the correct oil capacity, weight, and API specification is critical to maximizing the lifespan of Honda’s legendary powertrains.

Below is everything you need to know about performing an oil change on your 11th-generation 2024 Honda Civic.

Quick Answer

Here are the essential oil and filter specs for the most popular 2024 Honda Civic engines (1.5L Turbo and 2.0L Base):

• Recommended Oil Weight: 0W-20 Full Synthetic (0W-20 or 5W-30 for Type R)
• Oil Specification: API SP / ILSAC GF-6A
• OEM Oil Filter: Honda 15400-PLM-A02 (or 15400-PLM-A01)
• Aftermarket Filters: Fram XG7317, Mobil 1 M1-110A, Wix 51356

Capacity by Engine Option

The 2024 Civic is offered with three distinct engine choices. Make sure you check your owner's manual or vehicle emissions decal under the hood to confirm which engine you have before filling.

Note: Always double-check your dipstick after pouring in the recommended amount and running the engine for a minute to ensure the oil level sits squarely between the two dots.

Oil Change Interval

Honda uses a dynamic Maintenance Minder system that calculates oil life based on your driving habits, engine temperatures, and trip lengths.

• Normal Duty: The Maintenance Minder will typically illuminate the wrench icon between 7,500 and 10,000 miles (or 1 year).
• Severe Duty: If you frequently drive in stop-and-go traffic, mountainous regions, or extreme temperatures (hot or cold), expect the light to trigger around 5,000 miles. I highly recommend changing the oil at least every 5,000 miles if you own the 1.5L Turbo to help prevent fuel dilution and carbon buildup.

Drain Plug Torque

• Torque Spec: 30 lb-ft (40 Nm)
• Crush Washer: Always use a new 14mm aluminum crush washer (OEM Part # 94109-14000). Reusing the old washer is the #1 cause of slow driveway leaks after a DIY oil change.

How to Change the Oil

1. Warm up the engine: Run the car for 2-3 minutes to warm the oil, making it flow faster and carry out more suspended contaminants.
2. Lift the vehicle: Secure the Civic safely on jack stands or ramps. Engage the parking brake.
3. Remove the splash shield: You will need to drop the aluminum underbody tray (held on by Phillips head screws and flathead fasteners) to access the oil pan and filter.
4. Drain the oil: Position your catch pan, loosen the 17mm drain plug, and let the oil drain completely.
5. Replace the filter: Unscrew the old oil filter. Lubricate the rubber gasket of the new filter with fresh oil, then spin it on until hand-tight (usually 3/4 turn past gasket contact).
6. Reinstall drain plug: Install a new 14mm crush washer on the drain plug and torque to 30 lb-ft. Reinstall the splash shield.
7. Fill and check: Pour in the correct capacity of fresh 0W-20. Start the engine, check for leaks, shut it off, wait 3 minutes, and verify the fluid level on the dipstick.
8. Reset Maintenance Minder: Use the steering wheel controls to navigate to the Maintenance screen, select the Oil Life monitor, and hold the dial/button until it resets to 100%.

Common Issues & Tips

• Fuel Dilution on 1.5L Turbos: Honda's 1.5-liter Earth Dreams turbo engine (L15B7) is a direct-injection motor. In colder climates or during short trips where the engine doesn't reach optimal operating temperature, raw fuel can blow past the piston rings and mix with the oil, raising the level on the dipstick and giving it a strong gasoline smell. Changing your oil strictly at 5,000-mile intervals is the best preventative maintenance.
• Aluminum Skid Plate Screws: The factory skid plate fasteners are notoriously prone to stripping or seizing. Apply a tiny drop of anti-seize to the threads when reinstalling to save yourself a headache on your next oil change.
• A01 vs A02 Filters: You may see two different OEM part numbers for the Civic oil filter. The A01 is manufactured by Filtech, and the A02 is made by Fram (for Honda). Both meet Honda’s stringent factory specifications and are completely interchangeable.

Need an oil change? Find a trusted shop on Repairius.