Working on this vehicle? Write estimates, send inspections & invoice customers from your phone.

    Start 14-Day Free Trial
    ← All vehicle specs
    Fuse Box Diagram & Amperage

    2024 Peterbilt 579 Fuse Box Diagram & Amperage

    Everything on this vehicle

    Working on this 2024 Peterbilt 579? Run just this one job through Repairius.

    No big switch. Write the estimate, text it for approval, and get paid on your phone. Keep everything else the way it is.

    14-day free trial · credit card required · cancel anytime

    Quick answer

    The 2024 Peterbilt 579 typically has fuse boxes located in the following areas:

    • Under-hood: On the passenger side, near the firewall.
    • Dash Kick-Panel: On the passenger side, behind a removable panel.
    • Rear Cab (Sleeper): In the rear wall or overhead console of the sleeper compartment (if equipped).

    Under-Hood Fuse Box

    The under-hood fuse box on your 2024 Peterbilt 579 is primarily responsible for protecting critical engine and chassis components, as well as high-current circuits. It's usually located on the passenger side of the engine compartment, often near the firewall or battery box. Always refer to the fuse diagram printed on the inside of the fuse box cover for the most accurate information for your specific truck's configuration.

    Common Under-Hood Fuse and Relay Locations:

    Fuse #AmpColorCircuit / Component Protected
    F120AYellowECM/PCM (Engine Control Module/Powertrain Control Module)
    F210ARedIgnition Switch Circuit
    F330AGreenFuel Pump Relay Feed
    F420AYellowABS (Anti-lock Braking System)
    F515ABlueHeadlights Low Beam (Left)
    F615ABlueHeadlights Low Beam (Right)
    F715ABlueHeadlights High Beam (Left)
    F815ABlueHeadlights High Beam (Right)
    F920AYellowStarter Solenoid
    F1010ARedCabin Fuse Box Feed
    R1Fuel Pump Relay
    R2Starter Relay
    R3Headlight Relay

    Note: Fuse numbers and amperages may vary slightly depending on specific trim levels and optional equipment. Always consult your owner's manual and the fuse box lid diagram.


    Dash Kick-Panel Fuse Box (Passenger Side)

    This fuse box, often located behind a removable panel on the passenger side kick-panel, houses fuses for many of the truck's interior electrical systems, accessories, and some driver assistance features. Accessing it usually involves removing a few screws.

    Common Dash Kick-Panel Fuse Locations:

    Fuse #AmpColorCircuit / Component Protected
    F120AYellowBlower Motor
    F210ARedRadio / Infotainment System
    F315ABlueCigar Lighter / 12V Outlet (Dash)
    F410ARedA/C Clutch
    F55ATanInstrument Cluster
    F610ARedBrake Lights
    F715ABlueTail Lights / Park Lights
    F810ARedWipers
    F910ARedTurn Signals / Hazard Lights
    F1010ARedPower Windows
    R1Blower Motor Relay
    R2Accessory Delay Relay

    Note: The exact layout and amperage ratings can differ. Always verify with your truck's specific documentation.


    Rear Cab Fuse Box (Sleeper Compartment)

    For 2024 Peterbilt 579 models equipped with a sleeper, there's typically an additional fuse box located in the rear cab. This box often manages power for sleeper amenities such as interior lighting, refrigeration, power outlets, and potentially trailer-related functions.

    Common Rear Cab Fuse Locations:

    Fuse #AmpColorCircuit / Component Protected
    F120AYellowSleeper Interior Lights
    F215ABlue12V Outlet (Sleeper)
    F315ABlueRefrigerator Power (if equipped)
    F430AGreenTrailer Brake Controller (if equipped)
    F510ARedAuxiliary Heater
    F610ARedPower Inverter (Low Current)

    Note: Sleeper configurations vary widely. Always check the legend inside your sleeper fuse box cover.


    How to Test a Fuse

    Testing a fuse is a straightforward process that can help you diagnose electrical issues. Here's a common method:

    1. Locate the Fuse: Identify the suspect fuse using the diagrams above and your truck's fuse box legend.
    2. Visual Inspection: Many fuses have a visible wire element inside. If this wire is broken or melted, the fuse is blown. Some fuses have a small LED that illuminates when blown.
    3. Using a Fuse Tester (Recommended): A fuse tester is an inexpensive tool that makes testing easy. With the ignition off, touch the tester's probes to the two small metal test points on the top of the fuse. If the tester lights up on both sides, the fuse is good. If it only lights up on one side or not at all, the fuse is blown.
    4. Using a Multimeter: Set your multimeter to measure continuity (Ω or the continuity symbol). Remove the fuse from its slot. Touch one probe to each metal blade of the fuse. A good fuse will show a reading close to zero ohms or beep (indicating continuity). A blown fuse will show an

    Before you pull a fuse on the 2024 Peterbilt 579

    • Use the label printed on the panel cover or the owner's manual for your exact build. Layouts change with options, model year and build date, so a chart for another truck can be wrong.
    • Replace a blown fuse only with the same amp rating. A larger fuse can let wiring overheat.
    • A fuse that blows again right away means a short or failing component downstream. Find the cause before replacing it again.
    • A good fuse doesn't prove the circuit works — relays, grounds and connectors fail too.
    • Many heavy trucks have more than one power distribution point (cab, under-hood or near the batteries), and some circuits use circuit breakers instead of fuses. Some systems have 24-volt starting circuits; confirm the voltage before testing.
    • Disconnect the battery before working near high-current fuses or cables.

    Learn more: How fuses, relays and truck electrical systems work · Find mobile truck repair

    Need service on your Peterbilt 579?

    Request service from shops in your area.

    More specs for the 2024 Peterbilt 579

    Oil Capacity & Filter

    Capacity, weight, filter PN, drain plug torque, change interval.

    Fluid Type Specs

    Engine oil, coolant, ATF, diff, brake, PS, DEF — with OEM spec numbers.

    Coolant Capacity & Type

    Total system capacity, OEM coolant spec, flush interval, bleed tips.

    Transmission Fluid & Service

    Trans model, fluid spec, capacity, filter PN, service interval.

    Torque Specifications

    Lug nuts, drain plug, caliper, axle nut, plug, key fasteners.

    Brake Pad & Rotor Specs

    Pad PNs, rotor size, min thickness, caliper torque.

    Tire Size & Pressure

    OEM size, cold psi, bolt pattern, wheel size, TPMS.

    Battery Size & Group

    Group size, CCA, AGM/flooded, dimensions, reset note.

    A/C Refrigerant & Oil

    R-134a or R-1234yf, charge oz, PAG oil spec.

    Bulb Sizes (Headlight, Tail, Fog)

    Headlight, fog, tail, turn, reverse, interior.

    Factory Maintenance Schedule

    Service intervals by mileage, severe-duty notes, known issues.

    Towing Capacity & Payload

    Max tow, payload, GVWR/GCWR, hitch class by trim.

    Serpentine Belt Routing & Length

    Belt routing, length, rib count, OEM + aftermarket PNs.

    Wheel Alignment Specifications

    Camber, caster, toe ranges (front & rear), adjustability notes.

    Paint Color Codes

    All factory colors with paint codes, sticker location, touch-up tips.

    Wiper Blade Sizes

    Driver/passenger/rear blade size, attachment, OEM + cross-refs.

    Spark Plug Type & Gap

    Plug PN, gap, torque, interval by engine.

    Transmission & Axle Gear Ratios

    Trans gear ratios, axle ratios, RPO codes, tow vs MPG impact.

    Key Fob Programming

    DIY programming steps, FCC ID, fob PN, battery, transponder.

    Same spec — other model years

    Maintenance & repair guides

    Browse by make

    Running an auto or diesel repair shop?

    Compare Repairius to the shop software you're paying for

    $99.99/month (first location included), unlimited users, 14-day free trial.

    Values can vary by engine, trim and build date; check your VIN-specific service information. Updated 2026-06-26.

    Driving or Managing a Fleet?

    Use Dispatchtool for truck navigation, driver communication, dispatching, and fleet management.

    Visit Dispatchtool
    Run your shop from estimate to payment

    Don't overhaul your shop. Test Repairius on your next job.

    Repairius keeps estimates, work orders, real-time job assignment, customer and vehicle history, inventory, and payments in one place — on desktop and in your pocket.

    14-day free trial · credit card required · cancel anytime

    Not a mechanic? Send Repairius to your shop — they can run estimates, jobs, and invoices in one place.

    Know someone who needs this?

    Share this page with a mechanic, a shop owner, or a friend working on the same problem.

    Know a mechanic or shop owner Repairius could help?

    Send them Repairius in one tap. Free listing, online booking, reminders and the full shop workflow.

    Text them Email