2017 Chevrolet Equinox Oil Capacity & Filter

The 2017 Chevrolet Equinox takes between 4.2 and 6.0 quarts of oil, depending on the engine.

Quick answer

• 2.4L I4 Engine:
  • Oil Capacity: 5.0 quarts (4.7 liters)
  • Recommended Oil Weight: SAE 5W-20 or 0W-20
  • Oil Type Specification: Dexos1 Gen2 (or equivalent API SN Plus)
  • OEM Oil Filter: Consult dealer
  • Fram Oil Filter Cross-Reference: CH10246
  • Wix Oil Filter Cross-Reference: 57082
  • Mobil 1 Oil Filter Cross-Reference: M1C-153
• 3.6L V6 Engine:
  • Oil Capacity: 6.0 quarts (5.7 liters)
  • Recommended Oil Weight: SAE 5W-30
  • Oil Type Specification: Dexos1 Gen2
  • OEM Oil Filter: Consult dealer
  • Fram Oil Filter Cross-Reference: CH10295
  • Wix Oil Filter Cross-Reference: 57090
  • Mobil 1 Oil Filter Cross-Reference: M1C-151

Capacity by engine option

Oil change interval

Chevrolet recommends changing the oil in your 2017 Equinox based on the Oil Life Monitoring (OLM) system. This system takes into account various factors like driving style, engine revolutions, and operating temperature to determine the optimal oil change interval. As a general guideline:

• Normal Duty: Typically, the OLM will recommend an oil change between 7,500 and 10,000 miles.
• Severe Duty: If you frequently drive in demanding conditions such as heavy city traffic, dusty environments, extreme temperatures, or tow heavy loads, the OLM system may recommend an oil change closer to 3,000 to 5,000 miles. Always pay attention to the OLM indicator light on your dashboard.

Drain plug torque

The oil drain plug for both the 2.4L I4 and 3.6L V6 engines on the 2017 Chevrolet Equinox should be torqued to 18 lb-ft (24 Nm). Always use a new drain plug crush washer with every oil change to ensure a proper seal and prevent leaks.

How to change the oil

1. Warm up the engine: Drive the vehicle for 5-10 minutes to bring the oil up to operating temperature, allowing it to drain more easily.
2. Lift and secure: Safely lift the front of the vehicle using a jack and secure it with jack stands. This is crucial for safety.
3. Locate and drain: Place a drain pan under the oil pan. Locate the drain plug, remove it, and allow all the old oil to completely drain. Replace the drain plug with a new crush washer and tighten to the specified torque.
4. Replace the oil filter: Locate the oil filter. Unscrew and remove the old filter. Apply a thin coat of new oil to the gasket of the new filter before screwing it on hand-tight, then an additional 3/4 to 1 full turn (refer to filter instructions).
5. Refill with new oil: Lower the vehicle. Remove the oil cap and pour in the recommended amount of new oil for your engine. Do not overfill.
6. Check oil level and leaks: Start the engine and let it run for a minute to circulate the new oil. Turn off the engine, wait a few minutes, and then check the oil level with the dipstick. Top off if necessary. Inspect for any leaks around the drain plug and oil filter.
7. Reset Oil Life Monitor: Follow instructions in your owner's manual to reset the Oil Life Monitoring system.

Common issues / tips

• Oil Consumption (2.4L I4): Some 2017 Equinox models equipped with the 2.4L engine (LEAF) have been reported to exhibit higher-than-normal oil consumption. Regularly check your oil level between changes, especially if you have this engine.
• Proper Oil Specification: Always use Dexos1 Gen2 certified oil or an equivalent API SN Plus rated oil to ensure proper engine lubrication and maintain your warranty.
• Oil Filter Housing (2.4L I4): The 2.4L engine uses a cartridge-style oil filter located in a housing on top of the engine. Be careful not to overtighten the cap, as it can crack.
• PCV System Maintenance: A clogged Positive Crankcase Ventilation (PCV) system can contribute to oil consumption and other engine issues. It's a good idea to inspect and clean or replace the PCV valve as part of your routine maintenance.

Need an oil change? Find a trusted shop on Repairius.