2017 Chevrolet Silverado 1500 Oil Capacity & Filter Guide

The 2017 Chevrolet Silverado 1500 takes between 6.0 to 8.0 quarts (5.7 to 7.6 Liters) of 0W-20 or 5W-30 engine oil, depending on the engine.

Quick answer

• Total Oil Capacity: Varies by engine (see table below)
• Oil Viscosity: 0W-20 or 5W-30 (consult your owner's manual for specific engine requirement)
• Oil Specification: Dexos1 Gen 2 (or equivalent API SN Plus/SP rated oil)
• Oil Filter (ACDelco): PF63F (for most V6/V8 engines)
  • Fram Cross-Reference: PH10575
  • Wix Cross-Reference: 57060
  • Mobil 1 Cross-Reference: M1-113

Capacity by engine option

Note: The 4.3L V6 (LV3) engine in some 2017 models might specify 5W-30 if not equipped with Active Fuel Management (AFM)/Dynamic Fuel Management (DFM). Always double-check your owner's manual.

Oil change interval

For the 2017 Chevrolet Silverado 1500, the oil change interval is primarily dictated by the vehicle's Oil Life Monitoring (OLM) system. This system takes into account various factors such as engine revolutions, operating temperature, and driving habits to determine when an oil change is necessary.

• Normal Duty: Typically, the OLM will recommend an oil change between 7,500 to 10,000 miles (12,000 to 16,000 km) or approximately 12 months, whichever comes first.
• Severe Duty: If you frequently operate your Silverado under severe conditions (e.g., heavy towing, sustained high-speed driving in hot weather, extensive idling, dusty roads, or frequent short trips), the OLM will reduce the oil change interval, potentially signaling a change as early as 3,000-5,000 miles (4,800-8,000 km).

Always follow the indications of your vehicle's OLM system, and it's good practice to check your oil level regularly between changes.

Drain plug torque

The oil drain plug on the 2017 Chevrolet Silverado 1500 should be torqued to 18 lb-ft (24 Nm). Always use a new drain plug gasket or crush washer to ensure a proper seal and prevent leaks. Most new oil filters come with a new crush washer.

How to change the oil

1. Gather Supplies: Ensure you have the correct type and quantity of oil, a new oil filter, a new drain plug washer, a drain pan, a wrench for the drain plug, an oil filter wrench, and a funnel.
2. Warm Up Engine: Drive the vehicle for a few minutes to bring the oil to operating temperature. This helps the oil drain more completely.
3. Lift and Secure: Safely lift the front of the truck using a jack and secure it with jack stands. Always use jack stands for safety.
4. Locate Drain Plug: Place the drain pan under the oil pan, then locate and carefully remove the drain plug.
5. Drain Oil: Allow all the old oil to drain completely. This can take several minutes.
6. Replace Drain Plug: Once drained, reinstall the drain plug with a new crush washer and tighten to 18 lb-ft (24 Nm).
7. Remove Old Filter: Move the drain pan under the old oil filter. Using an oil filter wrench, loosen and remove the old filter. Be prepared for additional oil to come out.
8. Install New Filter: Apply a thin coat of new oil to the gasket of the new oil filter. Screw on the new filter by hand until it's snug, then turn an additional 3/4 to 1 full turn (or follow filter manufacturer's instructions).
9. Add New Oil: Using a funnel, add the recommended amount of new engine oil to your Silverado.
10. Check Level & Reset OLM: Start the engine and let it run for a minute to circulate the new oil. Check for any leaks. Turn off the engine, wait a few minutes, then check the oil level with the dipstick. Top off if necessary. Finally, reset the Oil Life Monitoring system according to your owner's manual (usually through the infotainment system or steering wheel controls).

Common issues / tips

• Active Fuel Management (AFM) / Dynamic Fuel Management (DFM): The 4.3L, 5.3L, and 6.2L engines often employ AFM/DFM technology. It is CRITICAL to use the specified Dexos1 Gen 2 (or later) oil viscosity, as these systems are sensitive to oil pressure and quality. Using incorrect oil can lead to lifter issues and excessive oil consumption.
• Oil Consumption: Some 2017 Silverado models, particularly those with AFM/DFM, may experience higher than usual oil consumption. Regularly check your oil level between changes and top off as needed. If consumption is excessive, consult a dealership or qualified mechanic.
• Oil Life Monitor (OLM) Accuracy: While generally reliable, the OLM is a guide. If you have any doubts about your driving conditions, it's always safer to change the oil slightly earlier than recommended, especially if you fall under severe duty conditions frequently.
• Genuine Parts: While aftermarket filters are readily available and often high quality, using genuine ACDelco oil filters is always a safe bet and ensures compatibility.

Need an oil change? Find a trusted shop on Repairius.