2024 Ford F-350 Super Duty Oil Capacity & Filter

The 2024 Ford F-350 Super Duty takes between 7.0 quarts and 13.0 quarts of oil depending on the engine.

Quick Answer

• Engine Oil Capacity:
  • 6.8L V8 Gas: 7.0 quarts (6.6 Liters)
  • 7.3L V8 Gas: 7.0 quarts (6.6 Liters)
  • 6.7L Power Stroke V8 Diesel: 13.0 quarts (12.3 Liters)
• Recommended Oil Weight:
  • 6.8L V8 Gas: SAE 5W-30
  • 7.3L V8 Gas: SAE 5W-30
  • 6.7L Power Stroke V8 Diesel: SAE 10W-30
• Oil Specification:
  • Gas Engines: API SP (or API SN PLUS for older models if SP is unavailable) with the "Starburst" certification mark. Ford WSS-M2C961-A1 (for 6.8L/7.3L) recommended.
  • Diesel Engine: Ford WSS-M2C171-F1
• Oil Filter Part Numbers:
  • 6.8L V8 Gas:
    • OEM: FL-910S
    • Fram Cross-Ref: PH2
    • Wix Cross-Ref: 51372
  • 7.3L V8 Gas:
    • OEM: FL-2124
    • Fram Cross-Ref: CH12678
    • Wix Cross-Ref: WL10010
  • 6.7L Power Stroke V8 Diesel:
    • OEM: FL-2124
    • Fram Cross-Ref: CH12678
    • Wix Cross-Ref: WL10010

Capacity by Engine Option

Oil Change Interval

Maintaining the correct oil change interval is crucial for the longevity of your 2024 F-350 Super Duty. Refer to your owner's manual for the most accurate information based on your specific vehicle and driving conditions.

• Normal Duty: For most driving conditions, an oil change is recommended every 7,500 to 10,000 miles or 6 months, whichever comes first.
• Severe Duty: If your F-350 regularly experiences conditions such as heavy towing, sustained idling, extreme temperatures, dusty environments, or frequent short trips, a severe duty interval is recommended. This typically means changing the oil every 5,000 miles or 6 months.

Drain Plug Torque

Properly torquing the drain plug prevents leaks and avoids damage to the oil pan. Always use a new drain plug crush washer with each oil change.

• Gas Engines (6.8L & 7.3L): Consult your owner's manual or a Ford service manual for the exact torque specification for your specific drain plug type (Ford often uses different styles). A common torque range is 19-25 lb-ft (26-34 Nm).
• 6.7L Power Stroke V8 Diesel: Consult your owner's manual or a Ford service manual for the exact torque specification. A common torque range is 20-25 lb-ft (27-34 Nm).

How to Change the Oil

Changing the oil on your 2024 Ford F-350 Super Duty is a routine maintenance task. Always refer to your factory service manual for detailed instructions and safety precautions.

1. Gather Supplies: New oil, oil filter, drain pan, wrench for drain plug, oil filter wrench, new crush washer (if applicable), rags, jack and jack stands (if needed), funnel.
2. Warm Up Engine: Drive the truck for a few minutes to bring the oil to operating temperature, which helps it drain more easily.
3. Position Vehicle: Safely park the truck on a level surface. If you need more clearance, use a jack and secure the truck with jack stands.
4. Locate Drain Plug: Find the oil pan and the drain plug underneath the engine.
5. Drain Oil: Place the drain pan below the drain plug. Carefully remove the drain plug and allow all the old oil to drain completely. Inspect the old oil for any metal flakes or unusual discoloration.
6. Replace Drain Plug: Install a new crush washer on the drain plug and reinstall it, tightening to the factory-specified torque.
7. Remove Old Filter: Locate the oil filter. Place the drain pan underneath it, as some oil will spill. Use an oil filter wrench to remove the old filter.
8. Prepare New Filter: Apply a thin film of new oil to the rubber gasket of the new oil filter.
9. Install New Filter: Hand-tighten the new oil filter until the gasket makes contact, then tighten an additional 3/4 to 1 full turn (refer to filter instructions for precise tightening).
10. Add New Oil: Using a funnel, slowly add the recommended amount and type of new oil through the oil fill cap on the engine.
11. Check Level: Start the engine and let it run for a minute to circulate the new oil. Shut off the engine, wait a few minutes, and then check the oil level with the dipstick. Add more oil if necessary to reach the "full" mark.
12. Inspect for Leaks: Check around the drain plug and oil filter for any signs of leaks.
13. Reset Oil Life Monitor: Consult your owner's manual for instructions on how to reset the oil life monitor.

Common Issues / Tips

• 6.7L Power Stroke Diesel Filter Housing: The 6.7L Power Stroke diesel engine often utilizes two oil filters – a primary filter and a smaller, often overlooked, secondary filter. Ensure both are changed the same time. The filter housing on these engines can sometimes be a bit tricky; ensure it's properly seated and torqued to prevent leaks.
• 7.3L "Godzilla" Gas Engine: This engine is known for its robust design. While generally trouble-free, ensure you use the specified oil weight and API SP standard to maintain optimal performance and protect against low-speed pre-ignition (LSPI).
• Diesel Exhaust Fluid (DEF) Contamination (Diesel only): While not a direct oil issue, ensure you are not accidentally adding DEF to your engine oil fill. The fill points are clearly marked, but in a rush, mistakes can happen. DEF in the oil can cause severe engine damage.
• Check for Leaks Regularly: Especially on heavy-duty trucks, regularly inspect for any oil leaks around the engine, oil pan, and filter. Catching a small leak early can prevent larger issues.

Need an oil change? Find a trusted shop on Repairius.