2022 Honda CR-V — Bulb Sizes (Headlight, Tail, Fog)

As an ASE-certified master technician, I know that keeping your vehicle’s lighting in top shape is one of the most critical safety aspects of driving. If you are maintaining a 2022 Honda CR-V, you are dealing with a transition generation where lighting varies significantly depending on your trim level. Lower trims utilize traditional halogen bulbs, while higher trims are equipped with modern, built-in LED assemblies.

Below is your ultimate guide to the 2022 Honda CR-V bulb sizes, upgrade considerations, and replacement tips.

Quick reference

Here is the quick reference chart for the most common replacement bulbs on the 2022 Honda CR-V. Note: If a bulb is listed as "LED Assembly," the bulb cannot be replaced individually; the entire housing must be replaced.

Halogen vs. Factory LED OEM Differences

The biggest variable for the 2022 CR-V is the trim level. The LX and Special Edition trims primarily use H11 halogen bulbs in a projector housing for low beams and 9005 halogens for high beams. The EX, EX-L, and Touring trims feature brilliant factory LED headlights. If your CR-V has factory LEDs, they are non-serviceable sealed units—if they fail, you replace the whole headlight assembly.

LED vs halogen upgrade considerations

If you have a lower-trim CR-V with halogen bulbs, upgrading to aftermarket LEDs is a very popular modification. However, there are a few things to keep in mind:

• Projector Housings: The 2022 CR-V halogen low beams use projector housings. When buying aftermarket LED H11 bulbs, make sure they are designed for projector housings (often featuring a 360-degree beam pattern or adjustable collars) so you don't create a dark spot in your field of vision.
• CANBUS Errors: Hondas from this generation are generally forgiving compared to European cars, but some cheaper LED kits might cause flickering or dashboard warning lights. Look for LEDs with built-in CANBUS decoders.
• Turn Signal Hyper-Flashing: If you upgrade your front or rear 7440 turn signals to LED, the lower resistance will cause the system to "hyper-flash" (blinking very rapidly). You will need to install load resistors in parallel with the wiring or buy "anti-hyper-flash" LED bulbs that have built-in resistors.

How to replace each bulb

• Low/High Beams (H11/9005): Accessible from under the hood. Turn the steering wheel fully to one side if you need extra room to reach behind the passenger side, but generally, you can access the dust caps directly behind the headlight assemblies. Twist counterclockwise to remove.
• Fog Lights: Easiest to access by removing the front lower engine splash shield or pulling back the plastic wheel well liner.
• Front Turn Signals: Located near the top/outer edge of the headlight housing. Twist the socket counterclockwise to pull the bulb out.
• Rear Turn and Reverse Lights: Open the liftgate and remove the small plastic access panels on the inner side of the taillight assemblies. Alternatively, you may need to unbolt the taillight housing (two 8mm bolts) and pull it straight back to access the sockets.
• License Plate Lights: Use a flathead screwdriver wrapped in tape to gently pry the plastic lens covers outward. Pull the 168 bulb straight out.
• Interior Dome/Map Lights: Carefully pry the clear plastic lenses off using a plastic trim tool (avoid metal screwdrivers to prevent cracking the brittle plastic). Pop the festoon or wedge bulbs out and press the new ones in.

Common lighting issues for this generation

The 2022 CR-V is a highly reliable vehicle, but there are a few minor lighting quirks:

1. Moisture in the Headlights: A small amount of condensation on humid days is normal, but pooling water inside the lens means the housing seal is broken.
2. Premature Halogen Burnout: If you touch the glass of an H11 or 9005 halogen bulb during installation, the oils from your fingers will cause it to overheat and fail quickly. Always wear gloves!
3. Rodent Damage: Honda's soy-based wiring insulation is notoriously attractive to rodents. If a bulb is completely unresponsive and the fuse is fine, check the wiring harness behind the headlight for chew marks.

Lighting is vital for your safety on the road. If you are dealing with complex electrical issues, broken LED assemblies, or just don't have the time to tackle a bulb replacement yourself, find a trusted shop on Repairius.