2014 Nissan Frontier Key Fob Programming

Quick reference

Step-by-step on-board programming

Good news for 2014 Frontier owners: you can program new remotes yourself without any special tools. This procedure will only program the remote unlock/lock/panic buttons, not the immobilizer chip in the key itself. You'll need to have all your remotes (including old ones) ready, as this procedure will erase any previously programmed remotes.

1. Lock all doors using the power lock switch on the driver's door.
2. Insert and remove the key from the ignition at least six times within 10 seconds. The hazard lights will flash to indicate that the system is in programming mode.
3. Insert the key into the ignition and turn it to the ACC position.
4. Within 5 seconds, press any button on the new remote. The hazard lights will flash once to confirm that the remote has been programmed.
5. If you have additional remotes to program (including your old ones), unlock and then lock the doors using the driver's side power lock switch.
6. Within 5 seconds, press any button on the next remote. The hazard lights will flash once to confirm programming.
7. Repeat steps 5 and 6 for up to four remotes.
8. When you are finished, turn the ignition to the OFF position. The hazard lights will flash twice to indicate the end of the programming mode.
9. Exit programming mode by turning the ignition off and removing the key. Test all remotes to ensure they are working correctly.

Battery replacement

Replacing the battery in your 2014 Nissan Frontier key fob is a simple task. You'll need a small flathead screwdriver and a CR2016 battery.

1. Locate the small notch on the side of the key fob.
2. Gently pry the two halves of the fob apart using the flathead screwdriver.
3. Carefully remove the old battery, paying attention to its orientation.
4. Insert the new CR2016 battery with the positive (+) side facing up.
5. Snap the two halves of the fob back together until they click into place.

Where to buy a replacement fob

• Dealer: The most expensive option, but you're guaranteed to get a genuine OEM fob. Expect to pay anywhere from $150 to $250 for the fob and programming.
• Locksmith: A locksmith can provide both OEM and aftermarket fobs and can often program them for less than the dealer. This is a great option if you also need a key cut. Costs can range from $100 to $200.
• Amazon/eBay: The most affordable option, with aftermarket fobs available for as little as $15-$30. However, be aware of a higher likelihood of receiving a defective or incorrect fob. You'll have to program it yourself or find a locksmith to do it for you, which will add to the overall cost.

If on-board programming isn't supported

While the remote functions of the 2014 Nissan Frontier are programmable on-board, the immobilizer transponder chip inside the key is not. This chip is what allows the engine to start. If you need a new key that will start the truck, it must be cut and the transponder chip must be programmed to the vehicle's computer using a specialized scan tool. This is a security measure to prevent theft.

Only a dealer or a qualified locksmith will have the necessary equipment to do this. A mobile locksmith can often come to you and complete the process in under an hour. Expect to pay between $75 and $150 for the programming service, in addition to the cost of the key and cutting.

Find a mobile locksmith or shop on Repairius.