2014 Nissan Frontier Oil Capacity & Filter Reference

The 2014 Nissan Frontier takes 4.9 quarts (4.6 liters) of 5W-30 engine oil for the 2.5L 4-cylinder engine, and 4.9 quarts (4.6 liters) of 5W-30 engine oil for the 4.0L V6 engine.

Quick Answer

Here's a quick reference for your 2014 Nissan Frontier:

• Oil Capacity: 4.9 quarts (4.6 liters) for both 2.5L and 4.0L engines
• Recommended Oil Weight: 5W-30
• Oil Type Specification: API SN or later, or ILSAC GF-5 or later
• OEM Oil Filter Part Number: 15208-9E000 (Nissan)
  • Aftermarket Cross-References:
    • Fram PH6607
    • Wix 51356
    • Mobil 1 M1-110

Capacity by Engine Option

Both available engines for the 2014 Nissan Frontier utilize the same oil capacity and weight:

Oil Change Interval

Nissan recommends adhering to the following oil change intervals for your 2014 Frontier:

• Normal Duty: Every 5,000 miles or 6 months, whichever comes first.
• Severe Duty: Every 3,750 miles or 3 months, whichever comes first. Severe duty conditions include frequent towing, off-road driving, extensive idling, or driving in very dusty conditions.

Drain Plug Torque

The oil drain plug for the 2014 Nissan Frontier should be torqued to 25-33 ft-lbs (34-45 Nm). It is highly recommended to replace the crush washer with a new one every time you change the oil to ensure a proper seal and prevent leaks. The crush washer helps to create a tight seal when the plug is torqued down and is designed to deform once, so reusing it can lead to oil leaks.

How to Change the Oil

Changing the oil on your 2014 Nissan Frontier is a straightforward process:

1. Warm up the engine slightly to allow the oil to flow more easily.
2. Park the vehicle on a level surface and engage the parking brake. Block the wheels for safety.
3. Safely lift and support the front of the vehicle using jack stands. Never rely solely on a jack.
4. Locate the oil drain plug on the oil pan beneath the engine. Place a drain pan underneath.
5. Remove the drain plug with the appropriate wrench. Be careful, as the oil may be hot. Allow all the old oil to drain completely.
6. Once drained, clean the drain plug and install a new crush washer. Reinstall the drain plug and tighten it to the specified torque (25-33 ft-lbs).
7. Locate the oil filter. Unscrew it using an oil filter wrench and allow any remaining oil to drain.
8. Apply a thin film of new oil to the rubber gasket of the new oil filter. Screw on the new filter hand-tight until the gasket makes contact, then tighten an additional 3/4 to one full turn.
9. Lower the vehicle safely.
10. Remove the oil cap and pour in the recommended amount of 5W-30 oil (4.9 quarts).
11. Replace the oil cap and start the engine. Let it run for a few minutes to circulate the new oil.
12. Shut off the engine, wait a few minutes, then check the oil level with the dipstick. Add more oil if necessary to reach the "FULL" mark.
13. Dispose of used oil and the old filter responsibly at a local recycling center.

Common Issues / Tips for this Generation

• Oil Consumption (4.0L V6): Some owners of the 4.0L V6 engine have reported higher than average oil consumption. It