Working on this vehicle? Write estimates, send inspections & invoice customers from your phone.

    Start 14-Day Free Trial
    ← All vehicle specs
    Serpentine Belt Routing & Length

    2015 Ram 1500 Serpentine Belt Guide

    AI-generated reference. Always verify torque values, fluid capacities, intervals, and procedures against the manufacturer's service manual or OEM repair information before performing work. Repairius is not liable for damage from acting on this content without verification.

    Working on this 2015 Ram 1500? Run just this one job through Repairius.

    No big switch. Write the estimate, text it for approval, and get paid on your phone. Keep everything else the way it is.

    14-day free trial · credit card required · cancel anytime

    Quick Answer

    • Belt Length: 92.25 inches (2343 mm)
    • Rib Count: 6-rib
    • OEM Belt Part Number: 53032860AB
    • Aftermarket Cross-References:
      • Gates: K060915
      • Dayco: 5060915
      • Continental: 4060915
    • Auto-Tensioner Part Number: 39912
    • Idler Pulley Part Number: 38008

    Belt Routing

    Before you remove the old belt, it is always a good idea to take a quick photo of the belt's routing for reference. The belt winds its way around numerous engine accessories. For the 2015 Ram 1500 with the 5.7L Hemi V8, the routing is as follows:

    1. Starts at the crankshaft pulley at the bottom.
    2. Wraps around the A/C compressor.
    3. Goes up and around the idler pulley.
    4. Then, it goes around the alternator.
    5. Next, it snakes around the power steering pump.
    6. Down to the water pump.
    7. Finally, it goes to the tensioner before returning to the crank pulley.

    How to Replace the Serpentine Belt

    To replace the belt, you will need a serpentine belt tool or a 3/8" breaker bar. Insert the tool into the square hole on the auto-tensioner arm. Rotate the tensioner to release the tension on the belt, and then you can slip the belt off the pulleys. When installing the new belt, make sure it is properly seated in the grooves of each pulley before releasing the tensioner.

    Replacement Interval

    It is recommended to inspect the serpentine belt at every oil change and replace it every 60,000 to 100,000 miles, or as needed. Consult your owner's manual for the specific interval for your vehicle.

    Signs of a Failing Belt or Tensioner

    A failing serpentine belt or tensioner can cause a variety of problems, including:

    • Squealing or chirping noises from the engine bay
    • Visible cracks, fraying, or glazing on the belt
    • Loss of power steering
    • Overheating engine
    • Dimming headlights
    • A/C not blowing cold

    If you notice any of these symptoms, it is important to have your serpentine belt and tensioner inspected and replaced as soon as possible.

    Find a trusted shop on Repairius.

    Need service on your Ram 1500?

    Request service from shops in your area.

    More specs for the 2015 Ram 1500

    Oil Capacity & Filter

    Capacity, weight, filter PN, drain plug torque, change interval.

    Fluid Type Specs

    Engine oil, coolant, ATF, diff, brake, PS, DEF — with OEM spec numbers.

    Coolant Capacity & Type

    Total system capacity, OEM coolant spec, flush interval, bleed tips.

    Transmission Fluid & Service

    Trans model, fluid spec, capacity, filter PN, service interval.

    Torque Specifications

    Lug nuts, drain plug, caliper, axle nut, plug, key fasteners.

    Brake Pad & Rotor Specs

    Pad PNs, rotor size, min thickness, caliper torque.

    Tire Size & Pressure

    OEM size, cold psi, bolt pattern, wheel size, TPMS.

    Battery Size & Group

    Group size, CCA, AGM/flooded, dimensions, reset note.

    A/C Refrigerant & Oil

    R-134a or R-1234yf, charge oz, PAG oil spec.

    Bulb Sizes (Headlight, Tail, Fog)

    Headlight, fog, tail, turn, reverse, interior.

    Factory Maintenance Schedule

    Service intervals by mileage, severe-duty notes, known issues.

    Towing Capacity & Payload

    Max tow, payload, GVWR/GCWR, hitch class by trim.

    Fuse Box Diagram & Amperage

    Fuse box locations, layout, amps, and what each fuse controls.

    Wheel Alignment Specifications

    Camber, caster, toe ranges (front & rear), adjustability notes.

    Paint Color Codes

    All factory colors with paint codes, sticker location, touch-up tips.

    Wiper Blade Sizes

    Driver/passenger/rear blade size, attachment, OEM + cross-refs.

    Spark Plug Type & Gap

    Plug PN, gap, torque, interval by engine.

    Transmission & Axle Gear Ratios

    Trans gear ratios, axle ratios, RPO codes, tow vs MPG impact.

    Key Fob Programming

    DIY programming steps, FCC ID, fob PN, battery, transponder.

    Same spec — other model years

    Maintenance & repair guides

    Browse by make

    Running an auto or diesel repair shop?

    Compare Repairius to the shop software you're paying for

    $99.99/month (first location included), unlimited users, 14-day free trial.

    Driving or Managing a Fleet?

    Use Dispatchtool for truck navigation, driver communication, dispatching, and fleet management.

    Visit Dispatchtool
    Run your shop from estimate to payment

    Don't overhaul your shop. Test Repairius on your next job.

    Repairius keeps estimates, work orders, real-time job assignment, customer and vehicle history, inventory, and payments in one place — on desktop and in your pocket.

    14-day free trial · credit card required · cancel anytime

    Not a mechanic? Send Repairius to your shop — they can run estimates, jobs, and invoices in one place.

    Know someone who needs this?

    Share this page with a mechanic, a shop owner, or a friend working on the same problem.

    Know a mechanic or shop owner Repairius could help?

    Send them Repairius in one tap. Free listing, online booking, reminders and the full shop workflow.

    Text them Email