2015 Toyota Camry Bulb Size Chart & Replacement Guide

As an ASE-certified master technician, I regularly see the 2015 Toyota Camry in the shop for routine maintenance, including lighting upgrades and replacements. The 2015 model year brought a significant refresh to the Camry, including some updates to the exterior lighting. Depending on whether you have an LE, SE, XLE, or XSE, you might have standard halogen projectors or factory LED low beams.

To help you get the job done right the first time, I’ve compiled a comprehensive bulb size guide for the 2015 Toyota Camry.

Quick Reference

Note: High-level trims (like the XLE V6 and XSE V6) often come equipped with factory LED low beams. If your car has OEM LEDs, they are non-serviceable sealed units and must be replaced as an entire assembly if they fail.

LED vs Halogen Upgrade Considerations

The 2015 Camry is a prime candidate for aftermarket LED upgrades, particularly for the H11 low beams and 9005 high beams. When upgrading from halogen to LED, keep the following in mind:

• CANBUS Errors & Flickering: Toyota's electrical system in this generation is generally very forgiving. You typically will not need CANBUS decoders or load resistors for the headlights. However, if you upgrade your turn signals (7444NA/7440A) to LED, you will experience hyper-flashing unless you install load resistors or use LED bulbs with built-in resistors.
• Clearance Issues: The Camry’s headlight housings have decent clearance, but bulky LED bulbs with large cooling fans or extended heat sinks might make it difficult to reinstall the factory dust covers. Always look for 1:1 ratio LED bulbs or compact fanless designs.
• DRL Operation: The 9005 high beam also acts as the Daytime Running Light (DRL) by running at a lower voltage. Some aftermarket LEDs cannot handle this voltage drop and will flicker or run at full brightness. Make sure your 9005 LEDs are specifically rated for DRL use.

How to Replace Each Bulb

• Low Beam (H11) & High Beam (9005): Both are easily accessible from under the hood. For the passenger side, you have plenty of room. On the driver side, you may need to unclip the battery tie-down or shift the washer fluid neck slightly for better hand clearance. Just twist counterclockwise to remove.
• Fog Lights (H16): It’s best to access these from underneath the vehicle. Remove the screws and plastic clips holding the front lower fender liner, peel it back, and reach up to twist the bulb out.
• Front Turn Signals (7444NA): Located in the lower bumper (depending on trim) or inner headlight housing. Reach down behind the bumper/housing, twist, and pull.
• Tail Lights / Brake Lights: The 2015 Camry uses factory LED strips for the primary brake and tail lights. If these fail, the entire housing must be replaced.
• Rear Turn (7440A) & Reverse (921): Open the trunk and pull back the trunk liner behind the taillight assembly by removing the plastic pop-clips. Twist the bulb sockets counterclockwise to pull them out.
• Interior Dome/Map Lights: Use a plastic trim removal tool (never a metal screwdriver) to gently pry the plastic lenses off. The bulbs simply pull straight out (168/194) or pop out of their spring contacts (DE3175).

Common Lighting Issues for this Generation

While the 2015 Camry is incredibly reliable, there are a few lighting quirks:

1. Moisture in the Headlights: Occasionally, the headlight seals degrade, allowing condensation to build up inside the lens. If catching it early, you can reseal the housing. Otherwise, an aftermarket replacement is necessary.
2. Melted Halogen Connectors: Standard H11 halogens run hot. Over time, the plastic harness connector can become brittle or melt, causing the low beam to cut out intermittently. Check the pigtail connector; if it's charred, splice in a new heavy-duty H11 ceramic pigtail.
3. DRL LED Flicker: As mentioned, putting standard LEDs in the high-beam slot often leads to a strobe-light effect during the day.

If you are dealing with wiring gremlins or need a full headlight assembly replaced and aimed perfectly, don't leave it to chance. Find a trusted shop on Repairius.