2016 Toyota Corolla Oil Capacity & Filter

The 2016 Toyota Corolla with the 1.8L 2ZR-FE engine takes 4.4 quarts (4.2 liters) of 0W-20 engine oil.

Quick Answer

• Oil Capacity: 4.4 US quarts (4.2 liters) with filter change.
• Recommended Oil Weight: 0W-20
• Oil Specification: API SN PLUS or later, or ILSAC GF-5 or later. Toyota recommends Toyota Genuine Motor Oil or equivalent.
• Oil Filter (OEM): Toyota 90915-YZZF2
  • Fram Cross-Reference: PH4967
  • Wix Cross-Reference: 57069
  • Mobil 1 Cross-Reference: M1-103

Capacity by Engine Option

Oil Change Interval

Toyota recommends the following oil change intervals for the 2016 Corolla:

• Normal Duty: Every 10,000 miles or 12 months, whichever comes first.
• Severe Duty: Every 5,000 miles or 6 months, whichever comes first. This applies if you frequently drive short distances, in dusty conditions, tow, or idle for extended periods.

Drain Plug Torque

The oil drain plug for the 2016 Toyota Corolla should be torqued to 30 ft-lb (41 Nm). Always use a new crush washer with each oil change to ensure a proper seal and prevent leaks. The OEM crush washer part number is typically 90430-12031 or 90430-12028.

How to Change the Oil

1. Warm up the engine slightly, then safely lift and support the front of the vehicle. Ensure the vehicle is level.
2. Locate the drain plug on the oil pan and place a drain pan underneath.
3. Remove the drain plug with a wrench (typically a 14mm or 17mm socket) and allow the old oil to drain completely.
4. While the oil is draining, locate and remove the spin-on oil filter using an appropriate oil filter wrench.
5. Apply a thin coat of new oil to the rubber gasket of the new oil filter. Screw on the new filter until the gasket makes contact, then tighten an additional 3/4 to 1 full turn (or follow filter manufacturer's instructions).
6. Once the oil has drained, replace the drain plug with a new crush washer and torque to 30 ft-lb (41 Nm).
7. Lower the vehicle and fill the engine with 4.2 quarts of the recommended 0W-20 oil. Start the car and let it run for a minute, then shut it off.
8. Check the oil level on the dipstick and top off as needed to the "full" mark.
9. Reset the maintenance reminder light on the dashboard.

Common Issues / Tips

• Underbody Cover: The 2016 Corolla has an underbody cover that needs to be removed to access the oil drain plug and filter. This typically involves removing several 10mm bolts and plastic clips.
• Oil Filter Nipple: Some aftermarket oil filters may not fit perfectly due to a slightly longer nipple on the OEM filter housing. Always ensure a snug and proper fit.
• Synthetic Oil: While not strictly required by Toyota for the 2016 Corolla, using a full synthetic 0W-20 oil can offer enhanced protection and performance, especially given the extended drain intervals. Always ensure the oil meets the API SN PLUS or ILSAC GF-5 specifications.
• Maintenance Light Reset: After an oil change, you'll need to manually reset the "MAINT REQD" light. This procedure typically involves turning the ignition to the "ON" position (without starting the engine), then pressing and holding the odometer trip reset knob until the light flashes and goes out.

Need an oil change? Find a trusted shop on Repairius.