2020 Honda CR-V Oil Capacity & Filter Specs

The 2020 Honda CR-V takes 3.7 quarts (3.5 liters) of 0W-20 synthetic motor oil for both the 1.5L turbocharged and 2.0L hybrid powertrains.

Quick Answer

• Oil Capacity: 3.7 US quarts (3.5 Liters)
• Recommended Oil Weight: 0W-20 Full Synthetic
• Oil Specification: API SP / ILSAC GF-6 or later
• OEM Oil Filter Part Number: Consult dealer (typically 15400-PLM-A02 or 15400-RTA-003)
• Aftermarket Oil Filter Cross-References:
  • Fram: PH7317
  • Wix: 51356
  • Mobil 1: M1-110

Capacity by Engine Option

Oil Change Interval

Honda recommends using the Maintenance Minder system for determining oil change intervals, which can vary based on driving conditions. However, general guidelines are:

• Normal Duty: Every 7,500 - 10,000 miles or 12 months, whichever comes first.
• Severe Duty: Every 3,000 - 5,000 miles or 6 months, whichever comes first. This applies if you frequently drive in extreme temperatures, tow, drive in dusty conditions, or make frequent short trips.

Drain Plug Torque

The oil drain plug for the 2020 Honda CR-V should be torqued to 29 lb-ft (39 Nm). Always replace the crush washer with a new one to prevent leaks.

How to Change the Oil

1. Gather your tools: new oil, new oil filter, oil filter wrench, drain pan, 17mm wrench for the drain plug, new crush washer, and gloves.
2. Warm up the engine slightly, then shut it off. This helps the oil drain better.
3. Locate the drain plug on the oil pan, place the drain pan underneath, and remove the plug with the 17mm wrench. Allow all the oil to drain.
4. While the oil is draining, remove the old oil filter using an oil filter wrench. Be prepared for some residual oil.
5. Apply a thin coat of new oil to the rubber gasket of the new oil filter. Install the new filter by hand until it's snug, then tighten an additional 3/4 to 1 full turn.
6. Replace the drain plug with a new crush washer and tighten to 29 lb-ft (39 Nm).
7. Fill the engine with 3.7 quarts of 0W-20 full synthetic oil.
8. Start the engine and let it run for a few minutes to circulate the new oil. Check for leaks around the filter and drain plug.
9. Shut off the engine, wait a few minutes for the oil to settle, then check the oil level on the dipstick and top off if necessary.
10. Reset the Maintenance Minder system.

Common Issues / Tips

• Dilution Concerns (1.5L Turbo): Owners of the 1.5L turbocharged engine (non-hybrid) should be aware of potential oil dilution issues, especially in colder climates or with frequent short trips. This can lead to increased oil levels on the dipstick and potentially premature engine wear. STICK to the severe duty interval for oil changes if you fall into these categories.
• Proper Oil Specification is Crucial: Always use 0W-20 full synthetic motor oil that meets or exceeds API SP or ILSAC GF-6 standards to ensure proper lubrication and fuel economy.
• Check Oil Regularly: Even modern engines can consume some oil. Check your oil level every few thousand miles, especially between changes, to ensure it remains at the proper level.

Need an oil change? Find a trusted shop on Repairius.