2017 Honda Pilot Oil Capacity & Filter

The 2017 Honda Pilot with the 3.5L V6 engine takes 5.7 US quarts (5.4 liters) of 0W-20 engine oil.

Quick Answer

• Oil Capacity: 5.7 US quarts (5.4 liters)
• Recommended Oil Weight: 0W-20
• Oil Type Specification: API Premium Grade 0W-20 Detergent Oil. Look for the API "starburst" certification mark.
• Oil Filter Part Numbers:
  • OEM Honda: 15400-RTA-003, 15400-PLC-004, 15400-PLM-A01, 15400-PLM-A02 (Confirm with your dealer as Honda often supersedes part numbers)
  • Fram: PH7317, PH7317-F
  • Wix: 51356
  • Mobil 1: M1-110

Capacity by Engine Option

For the 2017 Honda Pilot, only one engine option was available across all trims (LX, EX, EX-L, Touring, Elite):

Oil Change Interval

Honda recommends using the Maintenance Minder system to determine the optimal oil change interval for your 2017 Pilot. This system monitors various factors to calculate when maintenance is due. Generally:

• Normal Duty Driving: Expect an oil change interval of approximately 7,500 to 10,000 miles or 12 months, whichever comes first, indicated by the Maintenance Minder. The "A" or "B" service code will typically appear.
• Severe Duty Driving: If you frequently drive in harsh conditions such as extreme temperatures, stop-and-go traffic, towing, or dusty environments, the Maintenance Minder will likely shorten the interval. This could be as low as 3,000-5,000 miles. Always follow the Maintenance Minder's guidance.

Drain Plug Torque

The oil drain plug for the 2017 Honda Pilot (3.5L V6 engine) should be torqued to 29 lb-ft (39 N·m). Always use a new crush washer when performing an oil change to ensure a proper seal and prevent leaks. The OEM crush washer part number is typically 94109-14000.

How to Change the Oil

1. Warm Up: Drive the vehicle briefly to warm the engine oil, allowing it to drain more easily.
2. Lift & Secure: Safely lift the front of the vehicle using a jack and secure it with jack stands.
3. Locate & Drain: Place a drain pan under the oil pan. Locate the oil drain plug, remove it, and allow the old oil to drain completely. Be careful, as the oil may be hot.
4. Replace Plug & Washer: Install a new crush washer on the drain plug and reinstall it, tightening to 29 lb-ft (39 N·m).
5. Remove & Replace Filter: Locate the oil filter. Use an oil filter wrench to remove it. Apply a thin coat of new oil to the rubber gasket of the new filter before threading it on by hand until snug. Then, tighten it an additional 3/4 to 1 full turn.
6. Refill Oil: Lower the vehicle. Remove the oil cap and carefully pour in 5.7 quarts of fresh 0W-20 engine oil.
7. Check Level: Start the engine and let it run for a minute, then shut it off. Wait a few minutes for the oil to settle, then check the oil level on the dipstick. Add more oil if necessary to reach the "full" mark.
8. Reset Maintenance Minder: Follow the instructions in your owner's manual to reset the Maintenance Minder system.

Common Issues / Tips

• VCM (Variable Cylinder Management): The 3.5L V6 engine in the 2017 Pilot utilizes Honda's Variable Cylinder Management. Some owners report increased oil consumption associated with VCM, particularly if maintenance has been neglected. Regular oil changes with the correct 0W-20 oil are crucial to mitigate potential issues.
• Oil Filter Location: The oil filter on the 2017 Pilot's 3.5L V6 engine is conveniently located at the front of the engine, making it relatively easy to access during an oil change.
• Maintenance Minder: Always rely on the Maintenance Minder system for determining oil change intervals rather than a fixed mileage. It's a sophisticated system designed to optimize maintenance schedules based on your specific driving conditions.
• Crush Washer: Do not reuse the old crush washer on the drain plug. A new one is inexpensive and essential for preventing oil leaks.

Need an oil change? Find a trusted shop on Repairius.