2019 Mercedes-Benz Sprinter Oil Capacity & Filter Guide

A 2019 Mercedes-Benz Sprinter's oil capacity depends on the engine: the 2.0L gasoline engine requires 9.5 quarts (9.0 liters) of oil, while the 3.0L V6 diesel engine takes 13.2 quarts (12.5 liters).

Quick Answer

• Oil Capacity (2.0L Gas): 9.5 quarts / 9.0 liters
• Oil Capacity (3.0L V6 Diesel): 13.2 quarts / 12.5 liters
• Recommended Oil Weight (2.0L Gas): 5W-40 or 0W-40
• Recommended Oil Weight (3.0L V6 Diesel): 5W-30
• Oil Specification (2.0L Gas): Mercedes-Benz Spec 229.5
• Oil Specification (3.0L V6 Diesel): Mercedes-Benz Spec 229.52
• Oil Filter (2.0L Gas): OEM: A2741800610, Fram: CH11473, Wix: WL10358, Mobil 1: M1C-458
• Oil Filter (3.0L V6 Diesel): OEM: A6421800109, Fram: CH10682, Wix: WL10023, Mobil 1: M1C-457

Capacity by Engine Option

Oil Change Interval

For the 2019 Sprinter, the oil change interval is determined by the onboard Assyst Plus system, which monitors driving habits and conditions to calculate the optimal service time. However, a general guideline is up to 20,000 miles or two years for the diesel engine and 15,000 miles or one year for the gasoline engine under normal conditions.

Severe duty conditions will significantly shorten this interval. These include:

• Frequent short trips (under 10 miles)
• Heavy loads or towing
• Operation in dusty or sandy environments
• Extensive idling (common for delivery and work vans)
• Use in extreme hot or cold climates

Under these conditions, expect the Assyst Plus system to recommend an oil change much sooner, and it's wise to check the oil level and condition more frequently.

Drain Plug Torque

The oil drain plug on a 2019 Sprinter should be torqued to 22 lb-ft (30 Nm). It is critical to use a new crush washer with every oil change to prevent leaks. The crush washer is a one-time-use part and should not be reused.

How to Change the Oil

1. Warm up the engine to allow the oil to drain more easily.
2. Safely raise and support the vehicle.
3. Remove the underbody splash shield.
4. Position a drain pan, then remove the drain plug and allow the oil to drain completely.
5. While the oil is draining, replace the oil filter. The Sprinter uses a cartridge-style filter located on top of the engine.
6. Install the new drain plug with a new crush washer and torque it to spec.
7. Refill the engine with the correct amount and type of oil.
8. Start the engine, let it run for a minute, then turn it off and recheck the oil level, adding more if necessary.
9. Reset the oil life monitor/Assyst Plus system.

Common Issues / Tips

• Use the correct oil specification. This cannot be overstated. Using an oil that does not meet the required Mercedes-Benz specification (229.5 for gas, 229.52 for diesel) can lead to serious and expensive engine damage, including turbocharger and emissions system failures.
• No physical dipstick. Most 2019 Sprinters do not have a traditional dipstick. Oil level is checked electronically through the dashboard menu. It's important to perform this check on a level surface after the engine has been off for a few minutes.
• Cartridge filter housing. Be careful not to overtighten the oil filter housing cap. The torque specification is usually printed on the cap itself (typically 25 Nm).

Need an oil change? Find a trusted shop on Repairius.