2025 Toyota Tacoma Oil Capacity & Filter

The 2025 Toyota Tacoma takes 6.0 quarts (5.7 liters) of 0W-20 synthetic oil for all engine options.

Quick Answer

• Oil Capacity: 6.0 quarts (5.7 liters)
• Recommended Oil Weight: 0W-20 Full Synthetic
• Oil Specification: API SP / ILSAC GF-6A compliant
• OEM Oil Filter Part Number: Consult dealer (Part numbers for 2025 models are not yet officially released. It's likely to be similar to the 2024 model, but always verify.)
• Aftermarket Oil Filter Cross-References:
  • Fram: Consult dealer or Fram catalog when available (Likely Extra Guard CH12990 or equivalent)
  • Wix: Consult dealer or Wix catalog when available (Likely WL10010 or equivalent)
  • Mobil 1: Consult dealer or Mobil 1 catalog when available (Likely M1C-458A or equivalent)

Capacity by Engine Option

For the 2025 Toyota Tacoma, all available engine options are expected to utilize the same oil capacity.

Oil Change Interval

Toyota recommends the following oil change intervals for the 2025 Tacoma:

• Normal Duty: Every 10,000 miles or 12 months, whichever comes first.
• Severe Duty: Every 5,000 miles or 6 months, whichever comes first. This applies to conditions such as frequent towing, extensive idling, dusty conditions, or short trips in extreme cold.

Regular oil changes are crucial for the longevity and performance of your engine, especially with the advanced lubrication requirements of modern engines.

Drain Plug Torque

The oil drain plug for the 2025 Toyota Tacoma typically requires a torque of 30 ft-lbs (41 Nm). Always use a new crush washer with each oil change to ensure a proper seal and prevent leaks. The crush washer helps deform and create a tight seal when the drain plug is tightened.

How to Change the Oil

1. Warm the Engine: Drive the vehicle for a few minutes to bring the oil to operating temperature, making it flow more easily.
2. Lift and Secure: Safely lift the front of the Tacoma using a jack and secure it with jack stands on a level surface.
3. Locate Drain Plug: Place a suitable drain pan beneath the oil pan drain plug.
4. Drain Oil: Carefully remove the drain plug (typically 14mm or 17mm) and allow the old oil to drain completely. Be cautious, as the oil will be hot.
5. Replace Crush Washer: Once drained, replace the old crush washer with a new one on the drain plug and reinstall the plug, tightening it to 30 ft-lbs (41 Nm).
6. Remove Oil Filter: Place the drain pan under the oil filter housing. Use an appropriate oil filter wrench to remove the old oil filter. Be aware that additional oil will drain from the filter housing.
7. Install New Filter: Lubricate the O-ring of the new oil filter with fresh oil. Hand-tighten the new filter until snug, then give it an additional 3/4 to 1 full turn, or follow manufacturer's instructions. Do not overtighten.
8. Refill Oil: Lower the vehicle. Remove the oil filler cap on top of the engine and slowly pour in 6.0 quarts of the recommended 0W-20 full synthetic oil.
9. Check Level: Reinstall the oil filler cap. Start the engine and let it run for a minute to circulate the new oil. Turn off the engine, wait a few minutes, and check the oil level on the dipstick. Add more oil if necessary to reach the "full" mark.
10. Inspect for Leaks: Check for any leaks around the drain plug and oil filter.

Common Issues / Tips

• New Platform Considerations: As the 2025 Tacoma represents a new generation, be aware that future service bulletins or revisions to maintenance procedures might be issued by Toyota. Always check the latest owner's manual or consult an authorized dealer for the most up-to-date information.
• Turbocharged Engines: The 2025 Tacoma features turbocharged engines across the lineup. Turbocharged engines are particularly sensitive to oil quality and change intervals. Using the specified synthetic oil and adhering to recommended intervals is critical for turbocharger longevity.
• Oil Filter Housing: The 2025 Tacoma is expected to continue using a cartridge-style oil filter within a housing. Ensure you have the correct oil filter wrench for this type of filter. It's also good practice to replace the O-rings that come with the new filter element when servicing.
• Underbody Protection: Depending on the trim level, your Tacoma may have underbody skid plates that need to be removed to access the oil drain plug and filter. Factor this into your oil change time.

Need an oil change? Find a trusted shop on Repairius.