2016 Toyota Tundra Oil Capacity & Filter

The 2016 Toyota Tundra takes between 7.9 and 8.9 quarts of motor oil, depending on the engine.

Quick answer

Here’s a quick overview of the oil capacity and specifications for your 2016 Toyota Tundra:

• Oil Capacity:
  • 5.7L V8 (3UR-FE): 7.9 US Quarts (7.5 Liters) with filter
  • 4.6L V8 (1UR-FE): 7.9 US Quarts (7.5 Liters) with filter
  • 4.0L V6 (1GR-FE): 6.4 US Quarts (6.1 Liters) with filter
• Recommended Oil Weight: SAE 0W-20 for 5.7L and 4.6L V8; SAE 5W-30 for 4.0L V6
• Oil Type Specification: API SN or SP, or ILSAC GF-5 or GF-6
• Oil Filter Part Numbers:
  • OEM (Toyota): 90915-YZZD3 (5.7L/4.6L V8), 90915-YZZD1 (4.0L V6)
  • Fram equivalent: CH9972 (5.7L/4.6L V8), PH4967 (4.0L V6)
  • Wix equivalent: 57047 (5.7L/4.6L V8), 51348 (4.0L V6)

Capacity by engine option

Oil change interval

Toyota recommends the following oil change intervals for the 2016 Tundra:

• Normal Duty: Every 10,000 miles or 12 months, whichever comes first.
• Severe Duty: Every 5,000 miles or 6 months, whichever comes first. This applies if you frequently tow, idle for extended periods, drive in extreme temperatures, or on dusty roads.

Drain plug torque

The oil drain plug torque specification for all 2016 Toyota Tundra engines is 30 lb-ft (41 Nm). Always use a new crush washer with each oil change to ensure a proper seal and prevent leaks. Toyota part number for the crush washer is typically 90430-12031.

How to change the oil

Changing the oil on your 2016 Toyota Tundra is a straightforward process:

1. Warm up the engine to operating temperature, then shut it off.
2. Locate the drain plug on the oil pan and place a drain pan underneath.
3. Remove the drain plug and allow the oil to fully drain. Be careful, as the oil will be hot.
4. Locate and remove the oil filter. Be prepared for additional oil to drain. For V8 models, the oil filter is a cartridge type located in a housing.
5. Install the new oil filter, lubricating the O-rings (if applicable for cartridge filters) with fresh oil.
6. Reinstall the drain plug with a new crush washer and torque to specification.
7. Fill the engine with the recommended amount and type of new oil.
8. Start the engine and check for leaks. Allow the engine to run for a few minutes, then shut it off.
9. Check the oil level on the dipstick and top off if necessary.

Common issues / tips

• The 5.7L and 4.6L V8 engines use a cartridge-style oil filter, which requires a specific oil filter wrench to remove the housing. Ensure you have the correct tool before starting the change.
• Always use high-quality synthetic or synthetic blend oil that meets the specified API and ILSAC standards for optimal engine protection and longevity.
• Check your owner's manual for the most accurate and up-to-date information on maintenance schedules and specifications.
• Consider performing an oil analysis periodically, especially if you're extending your oil change intervals.

Need an oil change? Find a trusted shop on Repairius.