2020 Ford Ranger Oil Capacity & Filter Reference
AI-generated reference. Always verify torque values, fluid capacities, intervals, and procedures against the manufacturer's service manual or OEM repair information before performing work. Repairius is not liable for damage from acting on this content without verification.
Working on this 2020 Ford Ranger? Run just this one job through Repairius.
No big switch. Write the estimate, text it for approval, and get paid on your phone. Keep everything else the way it is.
14-day free trial · credit card required · cancel anytime
A 2020 Ford Ranger with the 2.3L EcoBoost I-4 engine takes 6.2 quarts (5.9 liters) of 5W-30 synthetic blend oil.
Quick Answer
- Oil Capacity: 6.2 qts / 5.9 L (with filter)
- Recommended Oil Weight: SAE 5W-30
- Oil Specification: API SP / dexos1 Gen3 (or Ford WSS-M2C961-A1)
- Oil Filter (OEM): Ford FL-910S
- Oil Filter (Aftermarket): Fram PH3614, Mobil 1 M1-102A, WIX 51348
Capacity by Engine Option
The 2020 Ford Ranger was offered with a single engine option in North America.
| Engine | Oil Capacity (quarts) | Recommended Oil Weight |
|---|---|---|
| 2.3L EcoBoost I-4 | 6.2 | 5W-30 |
Oil Change Interval
Ford recommends using its Intelligent Oil-Life Monitor® system to determine the appropriate oil change interval. However, for vehicles not equipped with this system or for owners who prefer a traditional schedule, the following intervals apply:
- Normal Duty: 7,500–10,000 miles or once a year, whichever comes first.
- Severe Duty: 3,500–5,000 miles. Severe duty conditions include frequent towing, extensive idling, dusty conditions, or primarily short-trip driving.
Drain Plug Torque
- Drain Plug Torque: 20 lb-ft (27 Nm)
- Crush Washer: It is best practice to replace the drain plug crush washer at every oil change to prevent leaks. Consult your local Ford dealer for the exact part number.
How to Change the Oil
- Warm up the engine for a few minutes to allow the oil to flow more easily.
- Remove the underbody skid plate (if equipped).
- Place a drain pan under the oil pan and remove the drain plug.
- While the oil is draining, remove the oil filter. Be prepared for some oil spillage.
- Once the oil has finished draining, clean the drain plug and surrounding area, then reinstall the drain plug with a new crush washer. Torque to 20 lb-ft.
- Lubricate the gasket on the new oil filter with fresh oil, then screw it on until it makes contact with the engine block. Tighten an additional three-quarters of a turn.
- Refill the engine with 6.2 quarts of 5W-30 oil.
- Start the engine and check for leaks.
Common Issues / Tips
The 2.3L EcoBoost engine in the 2020 Ranger is generally reliable. However, some owners have reported minor oil consumption between changes. It is a good practice to check the oil level every few weeks. Additionally, due to the location of the oil filter, removal can be messy. Placing a rag or funnel beneath the filter can help direct the flow of oil into the drain pan.
Need an oil change? Find a trusted shop on Repairius.
More specs for the 2020 Ford Ranger
Fluid Type Specs
Engine oil, coolant, ATF, diff, brake, PS, DEF — with OEM spec numbers.
Coolant Capacity & Type
Total system capacity, OEM coolant spec, flush interval, bleed tips.
Transmission Fluid & Service
Trans model, fluid spec, capacity, filter PN, service interval.
Torque Specifications
Lug nuts, drain plug, caliper, axle nut, plug, key fasteners.
Brake Pad & Rotor Specs
Pad PNs, rotor size, min thickness, caliper torque.
Tire Size & Pressure
OEM size, cold psi, bolt pattern, wheel size, TPMS.
Battery Size & Group
Group size, CCA, AGM/flooded, dimensions, reset note.
A/C Refrigerant & Oil
R-134a or R-1234yf, charge oz, PAG oil spec.
Bulb Sizes (Headlight, Tail, Fog)
Headlight, fog, tail, turn, reverse, interior.
Factory Maintenance Schedule
Service intervals by mileage, severe-duty notes, known issues.
Towing Capacity & Payload
Max tow, payload, GVWR/GCWR, hitch class by trim.
Fuse Box Diagram & Amperage
Fuse box locations, layout, amps, and what each fuse controls.
Serpentine Belt Routing & Length
Belt routing, length, rib count, OEM + aftermarket PNs.
Wheel Alignment Specifications
Camber, caster, toe ranges (front & rear), adjustability notes.
Paint Color Codes
All factory colors with paint codes, sticker location, touch-up tips.
Wiper Blade Sizes
Driver/passenger/rear blade size, attachment, OEM + cross-refs.
Spark Plug Type & Gap
Plug PN, gap, torque, interval by engine.
Transmission & Axle Gear Ratios
Trans gear ratios, axle ratios, RPO codes, tow vs MPG impact.
Key Fob Programming
DIY programming steps, FCC ID, fob PN, battery, transponder.
Same spec — other model years
Maintenance & repair guides
2020 Ford Ranger Maintenance Schedule →
Available maintenance guidance; confirm the manufacturer schedule.
Repair planning references →
Plan the scope of work; detailed procedures need configuration-matched evidence.
Browse by make
Running an auto or diesel repair shop?
Compare Repairius to the shop software you're paying for
$99.99/month (first location included), unlimited users, 14-day free trial.