2022 Ford Ranger Oil Capacity & Filter

The 2022 Ford Ranger with the 2.3L EcoBoost I-4 engine takes 6.2 quarts (5.9 liters) of 5W-30 synthetic blend oil.

Quick Answer

• Oil Capacity: 6.2 quarts (5.9 liters) with filter replacement
• Oil Viscosity: SAE 5W-30
• Oil Specification: Ford WSS-M2C961-A1 (API SP / ILSAC GF-6)
• Oil Filter (OEM): Ford FL-910S
• Oil Filter (Aftermarket):
  • Fram PH3614
  • Mobil 1 M1-102A
  • Wix 51348

Capacity by Engine Option

For the 2022 model year in North America, the Ford Ranger was offered with a single engine option.

Oil Change Interval

Ford recommends using its Intelligent Oil-Life Monitor® system to determine the oil change interval. The system will display a message in the information display when an oil change is due. However, the oil should be changed at least once a year or every 10,000 miles, whichever comes first.

• Normal Duty: When the "Oil change required" message appears, or at least once every 12 months / 10,000 miles.
• Severe Duty: Ford advises to follow the oil life monitor. Severe duty includes towing, extensive idling or low-speed driving, operating in extreme hot or cold temperatures, or using E85 fuel more than 50% of the time. Most owners should follow the severe schedule, which typically results in an interval of 5,000 to 7,500 miles.

Drain Plug Torque

• Drain Plug Torque: 21 lb-ft (28 Nm)
• Crush Washer: The 2.3L EcoBoost engine uses a plastic drain plug with a built-in seal that should be replaced at every oil change to prevent leaks. The OEM part number is Ford FT4Z-6730-A.

How to Change the Oil

1. Warm the engine for a few minutes to allow the oil to flow more easily.
2. Position a drain pan under the oil pan and remove the yellow plastic drain plug using a 3/8" drive ratchet or T-handle. No socket is needed.
3. Allow the oil to drain completely.
4. While the oil is draining, remove the oil filter, which is located on the driver's side of the engine. A filter wrench may be necessary.
5. Install the new oil filter after lightly lubricating the gasket with fresh oil. Hand-tighten until the gasket makes contact, then tighten an additional three-quarters of a turn.
6. Install the new plastic drain plug and torque to 21 lb-ft. Do not overtighten.
7. Fill the engine with 6.2 quarts of new 5W-30 oil.
8. Start the engine, let it run for 30 seconds, then shut it off. Check for leaks and re-check the oil level, topping off as needed.
9. Reset the Oil-Life Monitor® system through the steering wheel controls.

Common Issues / Tips

• Plastic Drain Plug: This is a point of contention for many owners. While designed for single use, they can be reused if the O-ring is in perfect condition, but replacement is the safest method to prevent leaks. Several aftermarket companies offer metal replacements.
• Skid Plate Removal: Accessing the drain plug and filter requires removing the underbody skid plate or fiber splash shield. This involves removing several bolts, so be prepared with the appropriate sockets.
• Correct Oil Spec: Using the correct Ford WSS-M2C961-A1 specification is crucial for the longevity of the turbocharged EcoBoost engine. This spec ensures proper lubrication and protection against low-speed pre-ignition (LSPI).

Need an oil change? Find a trusted shop on Repairius.