2017 Honda CR-V Fuse Box Diagram & Amperage

Quick answer

The 2017 Honda CR-V has three main fuse box locations: under the hood, under the dashboard (driver's side kick panel), and in the cargo area (rear right trim panel).

Under-Hood Fuse Box

This fuse box is located in the engine compartment, on the driver's side, near the battery. It contains fuses for major electrical components and relays.

Note: Relay locations are often marked on the fuse box lid. Always consult your vehicle's owner's manual or the fuse box lid for the exact relay positions.

Dash Fuse Box (Driver's Side Kick Panel)

This fuse box is located on the driver's side, typically behind a removable panel in the kick panel area. It controls many interior and accessory circuits.

Cargo Area Fuse Box (Rear Right Trim Panel)

This fuse box is located in the cargo area, often behind a removable panel in the right-hand side trim.

Note: Fuse configurations can vary slightly between trim levels and specific options. Always refer to the fuse diagram printed on the inside of your fuse box cover for the most accurate information for your specific vehicle.

How to test a fuse

Testing a fuse is a straightforward process that can help diagnose electrical issues. You'll need a fuse puller (usually found in the fuse box lid) and a multimeter or a fuse tester tool.

1. Locate the fuse: Identify the suspected bad fuse using the fuse box diagram.
2. Remove the fuse: Use the fuse puller to carefully remove the fuse from its slot. Never use metal tools as you could short other circuits.
3. Visual inspection: Hold the fuse up to a light and look at the metal wire inside. If the wire is broken or melted, the fuse is blown and needs to be replaced.
4. Test with a multimeter (optional but recommended):
   • Set your multimeter to the continuity setting (usually indicated by a speaker icon).
   • Touch one probe to each metal terminal on the fuse.
   • If the multimeter beeps or shows a reading close to zero ohms, the fuse is good. If there's no beep or it shows "OL" (open loop), the fuse is blown.
5. Test with a fuse tester: Insert the fuse into the designated slot on the tester. The tester will typically light up if the fuse is good.
6. Replace the fuse: If the fuse is blown, replace it with a new fuse of the exact same amperage and type. Using a fuse with a higher amperage can cause serious damage to your vehicle's electrical system.

Common blown fuses on this vehicle

While any fuse can blow, some are more commonly encountered on a 2017 Honda CR-V due to usage patterns or common electrical demands:

• Cigar Lighter / 12V Power Outlets (Fuse #7 in Dash Fuse Box): These fuses are often blown due to overloads from charging multiple devices or using high-power accessories. If your phone charger or portable air compressor suddenly stops working, check this fuse first.
• Radio / Infotainment (Fuse #1 in Dash Fuse Box): Issues with the radio not turning on, or certain functions failing, can often be traced back to this fuse. Before suspecting a more complex electrical issue, verify this fuse.
• Brake Lights (Fuse #9 in Dash Fuse Box): If your brake lights aren't working, this is a prime suspect. Always check this if you notice issues with your rear lighting.
• Headlights (Fuses #6, #7, #8, #9 in Under-Hood Fuse Box): If one of your headlights goes out, it's often the corresponding fuse. If both go out, it might be a relay or a more significant electrical problem, but start with the individual fuses.
• Blower Motor (Fuse #4 in Under-Hood Fuse Box): If your HVAC fan completely stops working, this high-amperage fuse is a common culprit. Ensure there isn't a blockage in the blower fan itself that could cause an overload.

Remember, if a new fuse blows immediately after installation, there is likely a short circuit or an underlying electrical problem that needs professional diagnosis. Repeatedly replacing a blowing fuse without addressing the root cause can lead to more severe damage.

Find a trusted shop on Repairius.