Working on this vehicle? Write estimates, send inspections & invoice customers from your phone.

    Start 14-Day Free Trial
    ← All vehicle specs
    Fluid Type Specs

    2022 Kenworth W900 Fluid Type Specs

    Working on this 2022 Kenworth W900? Run just this one job through Repairius.

    No big switch. Write the estimate, text it for approval, and get paid on your phone. Keep everything else the way it is.

    14-day free trial · credit card required · cancel anytime

    Quick answer — 2022 Kenworth W900

    Engine Oil
    10-12 gallons (PACCAR MX), 11 gallons (Cummins X15)
    Engine Coolant
    13-15 gallons
    Power Steering
    3-4 quarts
    Windshield Washer
    1.5 gallons

    From the table below. Confirm with your owner's manual for your exact engine.

    Quick Reference

    FluidType/SpecCapacity
    Engine OilAPI CK-4; SAE 15W-40 or 10W-3010-12 gallons (PACCAR MX), 11 gallons (Cummins X15)
    Engine CoolantPACCAR ELC (OAT)13-15 gallons
    Transmission FluidEaton PS-386, PS-278Varies by transmission model
    Rear DifferentialAPI GL-5, SAE 75W-90, 80W-140, or 85W-140Varies by axle model
    Brake FluidN/A (Full Air Brake System)N/A
    Power SteeringPACCAR PAO-68-PSF3-4 quarts
    Windshield Washer-1.5 gallons
    Diesel Exhaust FluidISO 2224115-30 gallons

    Engine Oil

    For the 2022 Kenworth W900, the choice of engine oil is critical to the longevity and performance of the PACCAR MX-13 and Cummins X15 engines. The required specification is API Service Category CK-4. This oil category was introduced for engines designed to meet 2017 and later greenhouse gas emission standards.

    • Viscosity Grade: The most commonly recommended viscosity grades are SAE 15W-40 and SAE 10W-30. The choice between them often depends on the ambient operating temperatures. SAE 15W-40 is a robust choice for a wide range of temperatures, while SAE 10W-30 can provide better fuel economy and improved cold-start performance in colder climates. Always consult your owner's manual for the specific recommendation based on your typical operating conditions.
    • Oil Pan Capacity: Engine oil capacity varies depending on the specific engine and oil pan configuration. For the PACCAR MX-13, the capacity is typically around 10-12 gallons (40-48 quarts). For the Cummins X15, the capacity is around 11 gallons (44 quarts).
    • Intervals: Oil change intervals can be up to 75,000 miles, but this is highly dependent on the duty cycle, fuel consumption, and whether oil analysis is being used to monitor the condition of the oil. For severe duty applications, much shorter intervals are necessary.

    Engine Coolant

    The cooling system in the 2022 Kenworth W900 is filled from the factory with PACCAR Extended Life Coolant (ELC). This is a Nitrite-Free Organic Additive Technology (OAT) coolant. It is crucial to use only a compatible OAT ELC for top-offs and coolant changes.

    • Specification: The coolant should meet the ASTM D6210 standard for heavy-duty diesel engine coolants.
    • Mixing Coolants: Never mix different coolant types. Adding conventional coolant or Hybrid OAT (HOAT) coolant to an OAT system will cause the additives to "fall out" of the solution, leading to the formation of a gel-like substance that can clog the radiator and cooling passages, resulting in engine overheating.
    • Capacity: The cooling system capacity is typically in the range of 13-15 gallons.
    • Intervals: PACCAR ELC is designed for long service intervals, often up to 1,000,000 miles or 8 years, but it's essential to check the coolant strength and freeze point periodically.

    Transmission Fluid

    The 2022 Kenworth W900 is available with a variety of manual and automated manual transmissions, primarily from Eaton. The correct fluid is critical for shift quality and transmission life.

    • Specification: For Eaton transmissions, such as the Endurant series, the required fluid specification is Eaton PS-386 (for newer models) or PS-278. These are synthetic, heavy-duty transmission fluids designed for extended drain intervals and improved performance.
    • Common Pitfalls: Do not use engine oil or generic gear oil in these transmissions unless explicitly approved by the manufacturer for a specific application. Using the wrong fluid can lead to poor shifting, overheating, and premature wear.
    • Intervals: With approved synthetic fluids, drain intervals can be as long as 500,000 miles for on-highway use.

    Rear Differential

    The rear axles require a robust gear oil to protect against the extreme pressures and temperatures of heavy-haul applications.

    • Specification: The gear oil must meet the API GL-5 service category. The most common viscosity grades are SAE 75W-90, 80W-140, or 85W-140. The heavier 140-weight oils are often specified for more severe-duty applications.
    • Friction Modifiers: If the axle is equipped with a limited-slip or locking differential, a friction modifier additive may be required. Always verify with the axle manufacturer's service information.
    • Intervals: Gear oil change intervals typically range from 250,000 to 500,000 miles, depending on the axle model, fluid type (synthetic vs. mineral), and application.

    Brake System

    The 2022 Kenworth W900 is equipped with a full air brake system. Therefore, it does not use hydraulic brake fluid (like DOT 3, DOT 4, or DOT 5.1). The air system uses compressed air to actuate the brakes. Maintenance involves regularly draining the air tanks to remove moisture and contaminants.

    Power Steering Fluid

    • Specification: The power steering system requires a high-quality, synthetic power steering fluid. PACCAR's PAO-68-PSF is the recommended fluid. This is a synthetic, non-dye fluid. Using automatic transmission fluid (ATF) or other non-specified fluids can cause damage to the steering gear and seals.
    • Capacity: The system capacity is approximately 3-4 quarts.

    Windshield Washer Fluid

    Any commercially available windshield washer fluid is acceptable. For winter use, a fluid with a low freezing point is recommended to prevent freezing in the lines and on the windshield. The reservoir holds approximately 1.5 gallons.

    Diesel Exhaust Fluid (DEF)

    For the selective catalytic reduction (SCR) system to function correctly and meet emissions regulations, high-quality Diesel Exhaust Fluid (DEF) is required.

    • Specification: The DEF must be ISO 22241 certified. This will be clearly marked on the container. In North America, this is also referred to as API-certified DEF.
    • Common Pitfalls: Using contaminated or low-quality DEF can damage the expensive SCR system components. Never add anything other than DEF to the DEF tank. The DEF tank cap is blue to prevent accidental filling with diesel fuel.
    • Capacity: DEF tank sizes typically range from 15 to 30 gallons, depending on the truck's configuration.

    Find a trusted shop on Repairius.

    Need service on your Kenworth W900?

    Your vehicle and question are already filled in — just add your location.

    More specs for the 2022 Kenworth W900

    Oil Capacity & Filter

    Capacity, weight, filter PN, drain plug torque, change interval.

    Coolant Capacity & Type

    Total system capacity, OEM coolant spec, flush interval, bleed tips.

    Transmission Fluid & Service

    Trans model, fluid spec, capacity, filter PN, service interval.

    Torque Specifications

    Lug nuts, drain plug, caliper, axle nut, plug, key fasteners.

    Brake Pad & Rotor Specs

    Pad PNs, rotor size, min thickness, caliper torque.

    Tire Size & Pressure

    OEM size, cold psi, bolt pattern, wheel size, TPMS.

    Battery Size & Group

    Group size, CCA, AGM/flooded, dimensions, reset note.

    A/C Refrigerant & Oil

    R-134a or R-1234yf, charge oz, PAG oil spec.

    Bulb Sizes (Headlight, Tail, Fog)

    Headlight, fog, tail, turn, reverse, interior.

    Factory Maintenance Schedule

    Service intervals by mileage, severe-duty notes, known issues.

    Towing Capacity & Payload

    Max tow, payload, GVWR/GCWR, hitch class by trim.

    Fuse Box Diagram & Amperage

    Fuse box locations, layout, amps, and what each fuse controls.

    Serpentine Belt Routing & Length

    Belt routing, length, rib count, OEM + aftermarket PNs.

    Wheel Alignment Specifications

    Camber, caster, toe ranges (front & rear), adjustability notes.

    Paint Color Codes

    All factory colors with paint codes, sticker location, touch-up tips.

    Wiper Blade Sizes

    Driver/passenger/rear blade size, attachment, OEM + cross-refs.

    Spark Plug Type & Gap

    Plug PN, gap, torque, interval by engine.

    Transmission & Axle Gear Ratios

    Trans gear ratios, axle ratios, RPO codes, tow vs MPG impact.

    Key Fob Programming

    DIY programming steps, FCC ID, fob PN, battery, transponder.

    Same spec — other model years

    Maintenance & repair guides

    Browse by make

    Running an auto or diesel repair shop?

    Compare Repairius to the shop software you're paying for

    $99.99/month (first location included), unlimited users, 14-day free trial.

    Values can vary by engine, trim and build date; check your VIN-specific service information. Updated 2026-08-25.

    Driving or Managing a Fleet?

    Use Dispatchtool for truck navigation, driver communication, dispatching, and fleet management.

    Visit Dispatchtool
    Run your shop from estimate to payment

    Don't overhaul your shop. Test Repairius on your next job.

    Repairius keeps estimates, work orders, real-time job assignment, customer and vehicle history, inventory, and payments in one place — on desktop and in your pocket.

    14-day free trial · credit card required · cancel anytime

    Not a mechanic? Send Repairius to your shop — they can run estimates, jobs, and invoices in one place.

    Know someone who needs this?

    Share this page with a mechanic, a shop owner, or a friend working on the same problem.

    Know a mechanic or shop owner Repairius could help?

    Send them Repairius in one tap. Free listing, online booking, reminders and the full shop workflow.

    Text them Email