2020 Nissan Titan Oil Capacity & Filter Guide

The 2020 Nissan Titan with its 5.6L V8 engine takes 7.3 quarts of 0W-20 engine oil.

Quick Answer

• Oil Capacity: 7.3 quarts (6.9 liters)
• Recommended Oil Weight: 0W-20
• Oil Specification: API SN PLUS or later, or ILSAC GF-6
• OEM Oil Filter Part Number: 15208-89F0E
• Aftermarket Oil Filter Cross-References:
  • Fram: PH7317
  • Wix: 57356
  • Mobil 1: M1-110

Capacity by Engine Option

For the 2020 Nissan Titan, there is only one engine option available.

Oil Change Interval

Nissan recommends the following oil change intervals for your 2020 Titan:

• Normal Duty: Every 10,000 miles or 12 months, whichever comes first.
• Severe Duty: Every 5,000 miles or 6 months, whichever comes first. This applies if you frequently tow, drive in dusty conditions, idle for extended periods, or drive in extreme temperatures.

Drain Plug Torque

The oil drain plug for the 2020 Nissan Titan should be torqued to 25 ft-lbs (34 Nm). Always use a new crush washer with each oil change to ensure a proper seal and prevent leaks. The OEM crush washer part number is typically included with the OEM oil filter or can be purchased separately (consult your dealer for specific part numbers if not included).

How to Change the Oil

1. Safely lift and support the front of the vehicle. Ensure the vehicle is level enough for proper draining.
2. Place a drain pan under the oil drain plug, located on the bottom of the oil pan.
3. Remove the drain plug and allow the oil to completely drain. Be cautious, as the oil may be hot.
4. Once drained, reinstall a new crush washer and the drain plug. Torque to 25 ft-lbs (34 Nm).
5. Locate the oil filter, typically on the passenger side of the engine block. Place a small drain pan underneath it.
6. Remove the old oil filter. Be aware that some oil will spill.
7. Apply a thin coat of new engine oil to the gasket of the new oil filter.
8. Screw on the new oil filter by hand until snug, then turn an additional 3/4 to 1 full turn. Do not overtighten.
9. Lower the vehicle.
10. Remove the engine oil filler cap and add 7.3 quarts of new 0W-20 engine oil.
11. Reinstall the oil filler cap.
12. Start the engine and let it run for a few minutes. Check for any leaks around the drain plug and oil filter.
13. Shut off the engine, wait a few minutes for the oil to settle, then check the oil level with the dipstick. Add more oil if necessary to bring it to the "full" mark.
14. Properly dispose of the used oil and filter.

Common Issues / Tips

• Proper Oil Level: The 5.6L V8 (VK56VD) engine is known to be sensitive to proper oil levels. Always ensure the oil level is at the "full" mark on the dipstick after an oil change, but avoid overfilling.
• Synthetic Oil: While not strictly required for normal duty by Nissan, using a full synthetic 0W-20 oil is highly recommended, especially for severe duty applications, as it provides superior protection and can help extend engine life.
• Oil Filter Access: The oil filter on the 2020 Titan is relatively easy to access compared to some other vehicles, making DIY oil changes straightforward.
• Resetting Maintenance Light: After your oil change, remember to reset the maintenance reminder light in your instrument cluster. Consult your owner's manual for specific instructions on how to do this.

Need an oil change? Find a trusted shop on Repairius.