2017 Toyota Camry Oil Capacity & Filter

The 2017 Toyota Camry takes 4.6 quarts (4.4 liters) of 0W-20 synthetic engine oil with a new oil filter.

Quick answer

• Oil Capacity: 4.6 US quarts (4.4 liters) with filter
• Recommended Oil Weight: 0W-20 Synthetic
• Oil Spec: API SN PLUS or later, or ILSAC GF-5 or later
• Oil Filter (OEM): Toyota #90915-YZZF2
• Oil Filter (Aftermarket Cross-Reference):
  • Fram: PH4967
  • Wix: 57047
  • Mobil 1: M1-103A

Capacity by engine option

Oil change interval

Toyota recommends adhering to the following oil change intervals for your 2017 Camry:

• Normal Duty: Every 10,000 miles or 12 months, whichever comes first.
• Severe Duty: Every 5,000 miles or 6 months, whichever comes first. This applies if you frequently drive in dusty conditions, tow, idle for extended periods, or drive in extreme temperatures.

Drain plug torque

The oil drain plug for the 2017 Toyota Camry should be torqued to 30 ft-lbs (41 Nm). Always replace the crush washer with a new one during every oil change to ensure a proper seal and prevent leaks. Toyota part number for the crush washer is #90430-12031.

How to change the oil

1. Warm up the engine: Drive the vehicle briefly to bring the oil to operating temperature.
2. Lift and secure: Safely lift the front of the vehicle using a jack and secure it with jack stands.
3. Locate drain plug: Place an oil drain pan beneath the oil pan and locate the drain plug.
4. Drain oil: Remove the drain plug with a wrench and allow the old oil to drain completely. Be careful, the oil will be hot.
5. Replace crush washer & plug: Install a new crush washer on the drain plug and re-install the drain plug, torquing it to 30 ft-lbs.
6. Remove oil filter: Locate the oil filter (it may require a special oil filter wrench). Unscrew and remove the old filter.
7. Prepare new filter: Apply a thin coat of new oil to the rubber gasket of the new filter.
8. Install new filter: Hand-tighten the new oil filter until the gasket makes contact, then tighten an additional 3/4 to 1 full turn.
9. Refill oil: Lower the vehicle and add the recommended amount of new 0W-20 synthetic oil through the oil filler cap.
10. Check level & inspect: Start the engine, let it run for a minute, then shut it off. Wait a few minutes and check the oil level on the dipstick. Top off if necessary. Inspect for any leaks.

Common issues / tips

• Spin-on vs. Cartridge Filter: Depending on the specific engine and model year within this generation of Camry (XV50), you might encounter either a traditional spin-on oil filter or a cartridge-style filter. The 2.5L 4-cylinder typically uses a spin-on filter, while the 3.5L V6 usually employs a cartridge filter. Ensure you have the correct filter type before starting your oil change.
• Plastic Undershield: The 2017 Camry often has a plastic undertray or splash shield that needs to be removed to access the oil drain plug and filter. Be mindful of the fasteners and ensure they are reinstalled correctly.
• Proper Oil Specification: Always use 0W-20 synthetic oil that meets API SN PLUS or later, or ILSAC GF-5 or later specifications to ensure proper engine lubrication and longevity. Using the wrong oil can lead to premature engine wear.
• Dispose of Used Oil Properly: Never pour used oil down the drain or into the environment. Take it to an authorized recycling center or auto parts store.

Need an oil change? Find a trusted shop on Repairius.