2018 Toyota Camry Oil Capacity & Filter

The 2018 Toyota Camry requires 4.8 quarts (4.5 liters) of 0W-20 engine oil for all engine options.

Quick Answer

• Oil Capacity: 4.8 quarts (4.5 liters)
• Recommended Oil Weight: 0W-20
• Oil Type Spec: API SN PLUS or later, ILSAC GF-5 or later
• OEM Oil Filter Part Number: 90915-YZZF2
• Aftermarket Oil Filter Cross-References:
  • Fram: PH4967
  • Wix: 57063
  • Mobil 1: M1-103

Capacity by Engine Option

All 2018 Toyota Camry models, regardless of engine (2.5L 4-cylinder or 3.5L V6), use the same oil capacity.

Oil Change Interval

Toyota recommends the following oil change intervals for the 2018 Camry:

• Normal Duty: Every 10,000 miles or 12 months, whichever comes first.
• Severe Duty: Every 5,000 miles or 6 months, whichever comes first. This applies if you frequently drive under conditions such as: short trips in cold weather, extensive idling, towing, or driving in dusty conditions.

Drain Plug Torque

The oil drain plug for the 2018 Toyota Camry should be torqued to 30 ft-lbs (41 Nm). Always replace the crush washer with a new one during every oil change to ensure a proper seal and prevent leaks. The OEM crush washer part number is 90430-12031.

How to Change the Oil

1. Gather your materials: fresh oil, new oil filter, new crush washer, drain pan, wrench for drain plug, oil filter wrench, and gloves.
2. Drive the vehicle for a few minutes to warm up the oil, then park on a level surface and engage the parking brake.
3. Locate the drain plug on the oil pan beneath the vehicle. Place the drain pan directly underneath.
4. Using the correct size wrench, carefully loosen and remove the drain plug, allowing the old oil to drain completely.
5. Once the oil has drained, replace the crush washer on the drain plug and reinsert it into the oil pan. Torque to 30 ft-lbs.
6. Locate the oil filter. Unscrew the old filter using an oil filter wrench (oil will leak out, so have your drain pan ready).
7. Apply a thin layer of new oil to the rubber gasket of the new oil filter. Screw the new filter on by hand until snug, then tighten an additional 3/4 to 1 full turn.
8. Remove the oil fill cap on top of the engine and pour in the recommended amount of new 0W-20 oil.
9. Replace the oil fill cap, start the engine, and let it run for a few minutes. Check for any leaks around the drain plug and oil filter.
10. Turn off the engine, wait a few minutes for the oil to settle, then check the oil level with the dipstick. Add more oil if necessary to reach the "full" mark.

Common Issues / Tips

• Cartridge vs. Canister Filter: The 2018 Camry uses a traditional spin-on canister oil filter, which is generally straightforward to replace.
• Plastic Undertray: The 2018 Camry may have a plastic undertray that needs to be removed to access the oil drain plug and filter. This typically involves removing several clips or bolts.
• Oil Consumption: While not a widespread issue for the 2018 model specifically, some Toyota engines have historically been known for oil consumption. Regularly checking your oil level between changes is good practice.
• Using the Correct Oil: Always use 0W-20 oil that meets the API SN PLUS or ILSAC GF-5 (or newer) specifications to ensure proper lubrication and maintain your warranty.

Need an oil change? Find a trusted shop on Repairius.